On Fri, Jun 01, 2018 at 04:58:27PM +0200, jacopo mondi wrote:

Hi Sakari,

On Fri, Jun 01, 2018 at 01:29:10PM +0300, Sakari Ailus wrote:

quoted

Hi Jacopo,

Thanks for the patch.

On Tue, May 29, 2018 at 05:05:53PM +0200, Jacopo Mondi wrote:

quoted

Add 'data-enable-active' property to endpoint node properties list.

The property allows to specify the polarity of the data-enable signal, which
when in active state determinates when data lanes have to sampled for valid
pixel data.

Lanes or lines? I understand this is forthe parallel interface.

Now I'm confused. Are the parallel data 'lines' and the CSI-2 one
'lanes'? I thought 'lanes' applies to both.. am I wrong?

"Lane" is conventionally refer to a differential pair of wires on a serial
bus such as CSI-2. "Line" is used of a wire on a parallel bus.

-- 
Sakari Ailus
sakari.ailus at linux.intel.com