Hello Yamada-san,

Thank you for your review and comments.
I'll fix this mail and other your replies!

Regards,
--
Katsuhiro Suzuki

-----Original Message-----
From: Masahiro Yamada <redacted>
Sent: Saturday, June 2, 2018 6:50 PM
To: Suzuki, Katsuhiro/?? ?? <redacted>
Cc: Mauro Carvalho Chehab <mchehab+samsung@kernel.org>;
linux-media at vger.kernel.org; Masami Hiramatsu [off-list ref];
Jassi Brar [off-list ref]; linux-arm-kernel
[off-list ref]; Linux Kernel Mailing List
[off-list ref]
Subject: Re: [PATCH 1/8] media: uniphier: add DT bindings documentation for UniPhier
HSC

2018-05-30 18:09 GMT+09:00 Katsuhiro Suzuki [off-list ref]:

quoted

This patch adds DT binding documentation for UniPhier HSC which is
MPEG2-TS input/output and demux subsystem.

Signed-off-by: Katsuhiro Suzuki <redacted>
---
 .../bindings/media/uniphier,hsc.txt           | 38 +++++++++++++++++++
 1 file changed, 38 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/media/uniphier,hsc.txt

diff --git a/Documentation/devicetree/bindings/media/uniphier,hsc.txt

b/Documentation/devicetree/bindings/media/uniphier,hsc.txt

quoted

new file mode 100644
index 000000000000..4242483b2ecc

--- /dev/null
+++ b/Documentation/devicetree/bindings/media/uniphier,hsc.txt

@@ -0,0 +1,38 @@
+Socionext UniPhier HSC (High-speed Stream Controller)
+
+The Socionext UniPhier HSC subsystem consists of MPEG2-TS input/output and
+demultiplexer cores in the same register space.
+
+This interface is support TS serial signals (clock, valid, sync, data) from
+external demodulators.
+
+Required properties:
+- compatible      : should be one of the following:
+                   "socionext,uniphier-ld11-hsc"
+                   "socionext,uniphier-ld20-hsc"
+- reg             : offset and length of the register set for the device.
+- interrupts      : should contain DMA and TSI error interrupt.
+- pinctrl-names   : should be "default".
+- pinctrl-0       : defined TS serial signal pins for external demodulators.
+- clock-names     : should include following entries:

"the following entries:"

quoted

+                    "hsc", "stdmac"
+- clocks          : a list of phandle, should contain an entry for each
+                    entry in clock-names.
+- reset-names     : should include following entries:

Ditto.

quoted

+                    "hsc", "stdmac"
+- resets          : a list of phandle, should contain an entry for each
+                    entry in reset-names.
+
+Example:
+       hsc {
+               compatible = "socionext,uniphier-ld20-hsc";
+               reg = <0x5c000000 0x100000>;
+               interrupts = <0 100 4>, <0 101 4>;
+               pinctrl-names = "default";
+               pinctrl-0 = <&pinctrl_hscin2_s>,
+                           <&pinctrl_hscin3_s>;
+               clock-names = "stdmac", "hsc";
+               clocks = <&sys_clk 8>, <&sys_clk 9>;
+               reset-names = "stdmac", "hsc";
+               resets = <&sys_rst 8>, <&sys_rst 9>;
+       };
--
2.17.0

--
Best Regards
Masahiro Yamada