[PATCH v2 2/3] dt-bindings: media: Add Allwinner V3s Camera Sensor Interface (CSI)
From: sakari.ailus@iki.fi (Sakari Ailus)
Date: 2017-12-19 11:53:34
Also in:
linux-devicetree, linux-media, lkml
Hi Yong, On Thu, Jul 27, 2017 at 01:01:36PM +0800, Yong Deng wrote:
Add binding documentation for Allwinner V3s CSI. Signed-off-by: Yong Deng <yong.deng@magewell.com>
DT bindings should precede the driver.
quoted hunk ↗ jump to hunk
--- .../devicetree/bindings/media/sun6i-csi.txt | 49 ++++++++++++++++++++++ 1 file changed, 49 insertions(+) create mode 100644 Documentation/devicetree/bindings/media/sun6i-csi.txtdiff --git a/Documentation/devicetree/bindings/media/sun6i-csi.txt b/Documentation/devicetree/bindings/media/sun6i-csi.txt new file mode 100644 index 0000000..f8d83f6 --- /dev/null +++ b/Documentation/devicetree/bindings/media/sun6i-csi.txt@@ -0,0 +1,49 @@ +Allwinner V3s Camera Sensor Interface +------------------------------ + +Required properties: + - compatible: value must be "allwinner,sun8i-v3s-csi"
What are sun6i and sun8i? Is this device first present in sun6i SoCs, whereas you have only defined bindings for sun8i?
+ - reg: base address and size of the memory-mapped region. + - interrupts: interrupt associated to this IP + - clocks: phandles to the clocks feeding the CSI + * ahb: the CSI interface clock + * mod: the CSI module clock + * ram: the CSI DRAM clock + - clock-names: the clock names mentioned above + - resets: phandles to the reset line driving the CSI + +- ports: A ports node with endpoint definitions as defined in + Documentation/devicetree/bindings/media/video-interfaces.txt.
Please document mandatory and optional endpoint properties relevant for the hardware.
+
+Example:
+
+ csi1: csi at 01cb4000 {
+ compatible = "allwinner,sun8i-v3s-csi";
+ reg = <0x01cb4000 0x1000>;
+ interrupts = <GIC_SPI 84 IRQ_TYPE_LEVEL_HIGH>;
+ clocks = <&ccu CLK_BUS_CSI>,
+ <&ccu CLK_CSI1_SCLK>,
+ <&ccu CLK_DRAM_CSI>;
+ clock-names = "ahb", "mod", "ram";
+ resets = <&ccu RST_BUS_CSI>;
+
+ port {
+ #address-cells = <1>;
+ #size-cells = <0>;
+
+ /* Parallel bus endpoint */
+ csi1_ep: endpoint {
+ remote-endpoint = <&adv7611_ep>;
+ bus-width = <16>;
+ data-shift = <0>;
+
+ /* If hsync-active/vsync-active are missing,
+ embedded BT.656 sync is used */
+ hsync-active = <0>; /* Active low */
+ vsync-active = <0>; /* Active low */
+ data-active = <1>; /* Active high */
+ pclk-sample = <1>; /* Rising */
+ };
+ };
+ };
+-- Kind regards, Sakari Ailus e-mail: sakari.ailus at iki.fi