[PATCH 3/8] ARM: dts: imx7d-cl-som: add nodes for usbh, and usbotg2
From: festevam@gmail.com (Fabio Estevam)
Date: 2017-12-01 20:13:24
Also in:
linux-devicetree, lkml
On Thu, Nov 30, 2017 at 6:14 PM, [off-list ref] wrote:
quoted hunk ↗ jump to hunk
From: Tyler Baker <redacted> Add device tree nodes for the USB hub, and USB OTG. i2c2 on this platform supports low state retention power state so lets use it. Signed-off-by: Tyler Baker <redacted> --- arch/arm/boot/dts/imx7d-cl-som-imx7.dts | 36 +++++++++++++++++++++++++-------- 1 file changed, 28 insertions(+), 8 deletions(-)diff --git a/arch/arm/boot/dts/imx7d-cl-som-imx7.dts b/arch/arm/boot/dts/imx7d-cl-som-imx7.dts index ae45af1..a9f690b 100644 --- a/arch/arm/boot/dts/imx7d-cl-som-imx7.dts +++ b/arch/arm/boot/dts/imx7d-cl-som-imx7.dts@@ -30,6 +30,16 @@ gpio = <&gpio1 5 GPIO_ACTIVE_HIGH>; enable-active-high; }; + + reg_usbh_nreset: regulator at 4 {
You should not use @4. Please make sure that regulators are not used inside simple-bus.
quoted hunk ↗ jump to hunk
- pinctrl_uart1: uart1grp { fsl,pins = < MX7D_PAD_UART1_TX_DATA__UART1_DCE_TX 0x79@@ -284,4 +297,11 @@ MX7D_PAD_LPSR_GPIO1_IO05__GPIO1_IO5 0x14 /* OTG PWREN */ >; }; -};\ No newline at end of file
This text here looks strange :-)
+
+ pinctrl_i2c2: i2c2grp {
+ fsl,pins = <
+ MX7D_PAD_LPSR_GPIO1_IO07__I2C2_SDA 0x4000000f
+ MX7D_PAD_LPSR_GPIO1_IO06__I2C2_SCL 0x4000000f
+ >;
+ };
+};
--
2.9.3
_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel at lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel