On Mon, Jul 31, 2017 at 5:19 PM, Simon Horman
[off-list ref] wrote:

Renesas ARM Based SoC DT Updates for v4.14

Changes of note:

* Add pin controller support to the RZ/G1M (r8a7743) SoC and
  RZ/A1 (r7s72100) SoCs now that the driver is available in v4.13-rc1.

* Add GPIO support to the RZ/G1M (r8a7743) SoC now that the driver
  is availabe in v4.13-rc1.

* Enable MMCIF0 and Ethernet AVB support on the RZ/G1M (r8a7743) SoC and
  the iWave-RZG1M-20M Qseven SOM. This depends on newly added pin
  controller support noted above.

* Use R-Car Gen 2 fallback binding for vin nodes

  This makes binding use consistent across R-Car Gen 2 SoCs.
  It does not have any run-time effect

* Use SMP jump stub SRAM region from DT on R-Car Gen 2 SoCs

  Geert Uytterhoeven says, "The R-Car Gen2 platform code for CPU core
  bringup needs to copy a jump stub to on-SoC SRAM.  Currently it uses a
  hardcoded address pointing to ICRAM1."

* Add Inter Connect RAM to R-Car Gen 2 and RZ/G1 SoCs

  Geert Uytterhoeven says, "R-Car Gen2 and RZ/G1 SoCs contain two or three
  blocks of SRAM, which can be used for several purposes.  One such purpose
  is holding a jump stub for CPU core bringup."
* Use generic compatible string for I2C EEPROM for RZ/A1 (r7s72100) SoC
  and koelsch board.

  This is part of a tree-wide cleanup by Javier Martinez Canillas

Pulled into next/dt, thanks!

       Arnd