On Tuesday 07 March 2017 12:12 AM, Tony Lindgren wrote:

* Keerthy [off-list ref] [170301 02:31]:

quoted

Currently the slope and offset values for calculating the
hot spot temperature of a particular thermal zone is part
of driver data. Pass them here instead and obtain the values
while of node parsing.

Tested for the slope and constant values on DRA7-EVM.

Keerthy (7):
  ARM: DRA7: Thermal: Add slope and offset values
  ARM: OMAP5: Thermal: Add slope and offset values
  ARM: OMAP443x: Thermal: Add slope and offset values
  ARM: OMAP4460: Thermal: Add slope and offset values
  thermal: ti-soc-thermal: Fetch slope and offset from DT
  thermal: ti-soc-thermal: Remove redundant constants
  thermal: ti-soc-thermal: Remove redundant code

Are the dts changes safe for me to pick separately into
omap-for-v4.12/dt?

Tony,

Seems like omap3 has no thermal_zone node defined in Device Tree.
It seems like it still uses driver data. I would need to add that as 
well. Can you confirm that? If yes i will send a new series with the 
omap3 device tree changes as well.

Thanks,
Keerthy

Regards,

Tony