[RESEND PATCH 2/3] ARM: davinci: hawk: Remove vbus and over current gpios

On Tuesday 22 November 2016 09:11 PM, Axel Haslam wrote:

Hi Sekhar

On Tue, Nov 22, 2016 at 11:37 AM, Sekhar Nori [off-list ref] wrote:

quoted

On Monday 21 November 2016 10:23 PM, Axel Haslam wrote:

quoted

The hawk board VBUS is fixed to a 5v source, and the over
current pin is actually not connected to the SoC.

Do not reseve these gpios for OHCI as they are not related
to usb.

Signed-off-by: Axel Haslam <redacted>

As discussed over the MMC/SD patches, this patch should be based off the
hawkboard schematic, not the LCDK schematic.

I looked at the hawkboard schematics and they are the same
as the lcdk as far as usb i concerned:

The ohci vbus is fixed to 5v, and the over current pins of the
TPS are not connected. so this patch should be ok for
both the hawk and the lcdk.

Alright! Thanks for checking.

Regards,
Sekhar