David Miller [off-list ref] writes:

From: Martin Blumenstingl <martin.blumenstingl@googlemail.com>
Date: Tue, 30 Aug 2016 20:49:28 +0200

quoted

On Mon, Aug 29, 2016 at 5:40 AM, David Miller [off-list ref] wrote:

quoted

From: Martin Blumenstingl <martin.blumenstingl@googlemail.com>
Date: Sun, 28 Aug 2016 18:16:32 +0200

quoted

This adds a DWMAC glue driver for the PRG_ETHERNET registers found in
Meson8b and GXBB SoCs. Based on the "old" meson6b-dwmac glue driver
the register layout is completely different.
Thus I introduced a separate driver.

Changes since v2:
- fixed unloading the glue driver when built as module. This pulls in a
  patch from Joachim Eastwood (thanks) to get our private data structure
  (bsp_priv).

This doesn't apply cleanly at all to the net-next tree, so I have
no idea where you expect these changes to be applied.

OK, maybe Kevin can me help out here as I think the patches should go
to various trees.

I think patches 1, 3 and 4 should go through the net-next tree (as
these touch drivers/net/ethernet/stmicro/stmmac/ and the corresponding
documentation).
Patch 2 should probably go through clk-meson-gxbb / clk-next (just
like the other clk changes we had).
The last patch (patch 5) should probably go through the ARM SoC tree
(just like the other dts changes we had).

@David, Kevin: would this be fine for you?

I would prefer if all of the patches went through one tree, that way
all the dependencies are satisfied in one place.

David, with your ack on the drivers/net changes, I can take them through
my tree for Amlogic SoCs (which then goes via the arm-soc tree.)

Note that there may be some minor tweaks yet to the clock handling based
on review comments.

Thanks,

Kevin