[PATCHv9 0/6] dmaengine: rcar-dmac: add iommu support for slave transfers

On Wed, Aug 10, 2016 at 01:22:13PM +0200, Niklas S?derlund wrote:

Hi,

This series tries to solve the problem with DMA with device registers
(MMIO registers) that are behind an IOMMU for the rcar-dmac driver. A
recent patch '9575632 (dmaengine: make slave address physical)'
clarifies that DMA slave address provided by clients is the physical
address. This puts the task of mapping the DMA slave address from a
phys_addr_t to a dma_addr_t on the DMA engine.

Without an IOMMU this is easy since the phys_addr_t and dma_addr_t are
the same and no special care is needed. However if you have a IOMMU you
need to map the DMA slave phys_addr_t to a dma_addr_t using something
like this.

This series is based on top of v4.8-rc1. And I'm hoping to be able to collect a
Ack from Russell King on patch 4/6 that adds the ARM specific part and then be
able to take the whole series through the dmaengine tree. If this is not the
best route I'm more then happy to do it another way.

It's tested on a Koelsch with CONFIG_IPMMU_VMSA and by enabling the
ipmmu_ds node in r8a7791.dtsi. I verified operation by interacting with
/dev/mmcblk1, i2c and the serial console which are devices behind the
iommu.

As I said in last one, the dmaengine parts look fine to me. But to go thru
dmaengine tree I would need ACK on non dmaengine patches.


-- 
~Vinod