[PATCH v3 4/4] musb: sunxi: Simplify dr_mode handling

Hi,

On Wed, Jun 08, 2016 at 12:30:20PM +0200, Hans de Goede wrote:

Hi,

On 08-06-16 12:23, Maxime Ripard wrote:

quoted

Hi,

On Sun, Jun 05, 2016 at 04:59:36PM +0200, Hans de Goede wrote:

quoted

phy-sun4i-usb now has proper dr_mode handling, it always registers an
extcon, and sends a notify with the mode (even when in peripheral- /
host-only mode) at least once.

So we can simply the sunxi musb glue by always registering its extcon
notifier and relying on sunxi_musb_work() to enable vbus when in
host-only mode.

This also enables host- and peripheral-only mode with vbus monitoring.

Signed-off-by: Hans de Goede <redacted>

It's been a bit painful to track all the patches needed so that it
applies properly, but I've finally been able to test it on a Sinlinx
SinA33 with peripheral-only mUSB, and it works like a charm.

You can add my Tested-by.

Great, thanks for testing.

This is the board which has an otg connector with vbus not connected,
right? Yet it does have a functional id-pin, right ?

It's that one, yes.

In that case you should be able to put it in dual-role mode (only
specify the id-pin in the phy dts node, no vbus / vbus-monitoring)
and then it _should_ work in host mode if you use a powered hub.

I'm fine with putting in peripheral-only mode, but as said
dual-role might work with a powered hub.

Good point, I'll test that.

Thanks!
Maxime

-- 
Maxime Ripard, Free Electrons
Embedded Linux, Kernel and Android engineering
http://free-electrons.com
-------------- next part --------------
A non-text attachment was scrubbed...
Name: signature.asc
Type: application/pgp-signature
Size: 819 bytes
Desc: not available
URL: <http://lists.infradead.org/pipermail/linux-arm-kernel/attachments/20160615/4ee36279/attachment-0001.sig>