Hi CK,


On Mon, 2016-05-23 at 17:09 +0800, CK Hu wrote:

Hi, YT:

Some comments below.

On Fri, 2016-05-20 at 23:05 +0800, yt.shen at mediatek.com wrote:

quoted

From: YT Shen <redacted>

This patch add support for the Mediatek MT2701 DISP subsystem.
There is only one OVL engine in MT2701.

Signed-off-by: YT Shen <redacted>
 
+static void mtk_ddp_mux_sel(void __iomem *config_regs,
+			    enum mtk_ddp_comp_id cur, enum mtk_ddp_comp_id next)
+{
+	if (cur == DDP_COMPONENT_BLS && next == DDP_COMPONENT_DSI0) {
+		writel_relaxed(BLS_TO_DSI_RDMA1_TO_DPI1,
+			       config_regs + DISP_REG_CONFIG_OUT_SEL);
+	}
+}
+

The function name 'mux' looks strange. The register written here
controls the single output selection. I prefer to rename it as
mtk_ddp_sout_sel().

OK, I will rename this function in the next version.

quoted

 
-static const enum mtk_ddp_comp_id mtk_ddp_main[] = {
+static const enum mtk_ddp_comp_id mtk_ddp_main_2701[] = {
+	DDP_COMPONENT_OVL0,
+	DDP_COMPONENT_RDMA0,
+	DDP_COMPONENT_COLOR0,
+	DDP_COMPONENT_BLS,
+	DDP_COMPONENT_DSI0,
+};
+
+static const enum mtk_ddp_comp_id mtk_ddp_ext_2701[] = {
+	DDP_COMPONENT_OVL0,
+	DDP_COMPONENT_DSI0,
+};
+

These two pipelines has the same component such as OVL0 and DSI0. I
think user program could not enable both crtc at the same time. Maybe
MT2701 has only one crtc, so you should modify initial flow to create
only one crtc for main display. Or it's typo for external display pipe,
please correct it.

MT2701 hardware can support two output concurrently, but we haven't
implement DPI path yet.  We will change it like this:
static const enum mtk_ddp_comp_id mtk_ddp_ext_2701[] = {
	DDP_COMPONENT_RDMA1,
	DDP_COMPONENT_DPI0,
};

Thanks.
yt.shen

Regards,
CK