[PATCH v5 2/4] Documentation: Bindings: Add STM32 DWMAC glue
From: Chen-Yu Tsai <hidden>
Date: 2016-03-18 16:00:51
Also in:
linux-devicetree, lkml, netdev
Hi, On Fri, Mar 18, 2016 at 11:37 PM, Alexandre TORGUE [off-list ref] wrote:
quoted hunk ↗ jump to hunk
Signed-off-by: Alexandre TORGUE <redacted>diff --git a/Documentation/devicetree/bindings/net/stm32-dwmac.txt b/Documentation/devicetree/bindings/net/stm32-dwmac.txt new file mode 100644 index 0000000..ada2aa4 --- /dev/null +++ b/Documentation/devicetree/bindings/net/stm32-dwmac.txt@@ -0,0 +1,32 @@ +STMicroelectronics STM32 / MCU DWMAC glue layer controller + +This file documents platform glue layer for stmmac. +Please see stmmac.txt for the other unchanged properties. + +The device node has following properties. + +Required properties: +- compatible: Should be "st,stm32-dwmac" to select glue, and + "snps,dwmac-3.50a" to select IP vesrion.
If you need have sort of hardware glue, then it is not compatible. ChenYu
+- clocks: Must contain a phandle for each entry in clock-names.
+- clock-names: Should be "stmmaceth" for the host clock.
+ Should be "tx-clk" for the MAC TX clock.
+ Should be "rx-clk" for the MAC RX clock.
+- st,syscon : Should be phandle/offset pair. The phandle to the syscon node which
+ encompases the glue register, and the offset of the control register.
+Example:
+
+ ethernet0: dwmac at 40028000 {
+ compatible = "st,stm32-dwmac", "snps,dwmac-3.50a";
+ status = "disabled";
+ reg = <0x40028000 0x8000>;
+ reg-names = "stmmaceth";
+ interrupts = <0 61 0>, <0 62 0>;
+ interrupt-names = "macirq", "eth_wake_irq";
+ clock-names = "stmmaceth", "tx-clk", "rx-clk";
+ clocks = <&rcc 0 25>, <&rcc 0 26>, <&rcc 0 27>;
+ st,syscon = <&syscfg 0x4>;
+ snps,pbl = <8>;
+ snps,mixed-burst;
+ dma-ranges;
+ };
--
1.9.1
_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel at lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel