Support configurable conversion mode through sysfs. So far, the
mode used was low-power, which is enabled by default now. Beside
that, the modes normal and high-speed are selectable as well.

Use the new device tree property which specifies the maximum ADC
conversion clock frequencies. Depending on the mode used, the
available resulting conversion frequency are calculated
dynamically.

Acked-by: Fugang Duan <redacted>
Signed-off-by: Stefan Agner <stefan@agner.ch>
---
 Documentation/ABI/testing/sysfs-bus-iio-vf610      |   7 +
 .../devicetree/bindings/iio/adc/vf610-adc.txt      |   9 ++
 drivers/iio/adc/vf610_adc.c                        | 146 +++++++++++++++------
 3 files changed, 120 insertions(+), 42 deletions(-)
 create mode 100644 Documentation/ABI/testing/sysfs-bus-iio-vf610

diff --git a/Documentation/ABI/testing/sysfs-bus-iio-vf610 b/Documentation/ABI/testing/sysfs-bus-iio-vf610
new file mode 100644
index 0000000..ecbc1f4
--- /dev/null
+++ b/Documentation/ABI/testing/sysfs-bus-iio-vf610

@@ -0,0 +1,7 @@
+What:          /sys/bus/iio/devices/iio:deviceX/conversion_mode
+KernelVersion: 4.2
+Contact:       linux-iio at vger.kernel.org
+Description:
+               Specifies the hardware conversion mode used. The three
+               available modes are "normal", "high-speed" and "low-power",
+               where the last is the default mode.

diff --git a/Documentation/devicetree/bindings/iio/adc/vf610-adc.txt b/Documentation/devicetree/bindings/iio/adc/vf610-adc.txt
index 1a4a43d..3eb40e2 100644
--- a/Documentation/devicetree/bindings/iio/adc/vf610-adc.txt
+++ b/Documentation/devicetree/bindings/iio/adc/vf610-adc.txt

@@ -11,6 +11,13 @@ Required properties:
 - clock-names: Must contain "adc", matching entry in the clocks property.
 - vref-supply: The regulator supply ADC reference voltage.

+Recommended properties:
+- fsl,adck-max-frequency: Maximum frequencies according to datasheets operating
+  requirements. Three values are required, depending on conversion mode:
+  - Frequency in normal mode (ADLPC=0, ADHSC=0)
+  - Frequency in high-speed mode (ADLPC=0, ADHSC=1)
+  - Frequency in low-power mode (ADLPC=1, ADHSC=0)