[PATCH 2/6] ahci: st: Update the DT example for how to obtain the PHY.
From: Rob Herring <hidden>
Date: 2015-02-25 14:33:44
Also in:
linux-devicetree, lkml
On Wed, Feb 25, 2015 at 7:36 AM, Peter Griffin [off-list ref] wrote:
The example is wrong in that the phys property should take a phandle to the phy port. Also with the changing over to generic PHY type constants we also update this as well. Signed-off-by: Peter Griffin <peter.griffin@linaro.org>
We seem to have a variety of ways to describe phy's with SATA controllers. Some consistency would have been nice. However, as this is a doc correction: Acked-by: Rob Herring <robh@kernel.org>
quoted hunk ↗ jump to hunk
--- Documentation/devicetree/bindings/ata/ahci-st.txt | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-)diff --git a/Documentation/devicetree/bindings/ata/ahci-st.txt b/Documentation/devicetree/bindings/ata/ahci-st.txt index 0574a77..1331202 100644 --- a/Documentation/devicetree/bindings/ata/ahci-st.txt +++ b/Documentation/devicetree/bindings/ata/ahci-st.txt@@ -11,7 +11,7 @@ Required properties: - reset-names : Associated names must be; "pwr-dwn" and "sw-rst" - clocks : The phandle for the clock - clock-names : Associated name must be; "ahci_clk" - - phys : The phandle for the PHY device + - phys : The phandle for the PHY port - phy-names : Associated name must be; "ahci_phy" Example:@@ -21,7 +21,7 @@ Example: reg = <0xfe380000 0x1000>; interrupts = <GIC_SPI 157 IRQ_TYPE_NONE>; interrupt-names = "hostc"; - phys = <&miphy365x_phy MIPHY_PORT_0 MIPHY_TYPE_SATA>; + phys = <&phy_port0 PHY_TYPE_SATA>; phy-names = "ahci_phy"; resets = <&powerdown STIH416_SATA0_POWERDOWN>, <&softreset STIH416_SATA0_SOFTRESET>; --1.9.1 _______________________________________________ linux-arm-kernel mailing list linux-arm-kernel at lists.infradead.org http://lists.infradead.org/mailman/listinfo/linux-arm-kernel