Hi, Balbi

On 02/20/2015 10:41 PM, Felipe Balbi wrote:

quoted

+static void hi6220_start_peripheral(struct hi6220_priv *priv, bool on)
+{
+	struct usb_otg *otg = priv->phy.otg;
+
+	if (!otg->gadget)
+		return;
+
+	if (on)
+		usb_gadget_connect(otg->gadget);
+	else
+		usb_gadget_disconnect(otg->gadget);

why is the PHY fiddling with pullups ?

We use this to enable/disable otg gadget mode.

The gpio_id & gpio_vbus are used to distinguish otg gadget mode or host 
mode.
When micro usb or otg device attached to otg, gpio_vbus falling down.
And gpio_id = 1 is micro usb, gpio_id = 0 is otg device.

So when micro usb attached, we enable gadget mode; while micro usb 
detached, we disable gadget mode, and dwc2 will automatically set to 
host mode.

quoted

+}
+
+static void hi6220_detect_work(struct work_struct *work)
+{
+	struct hi6220_priv *priv =
+		container_of(work, struct hi6220_priv, work.work);
+	int gpio_id, gpio_vbus;
+	enum usb_otg_state state;
+
+	if (!gpio_is_valid(priv->gpio_id) || !gpio_is_valid(priv->gpio_vbus))
+		return;
+
+	gpio_id = gpio_get_value_cansleep(priv->gpio_id);
+	gpio_vbus = gpio_get_value_cansleep(priv->gpio_vbus);

looks like this should be using extcon

Not used extcon before.
However, we need gpio_vbus interrupt.
Checked phy-tahvo.c and phy-omap-otg.c, not find extcon related with 
interrupt.
Will investigate tomorrow.

quoted

+
+	if (gpio_vbus == 0) {
+		if (gpio_id == 1)
+			state = OTG_STATE_B_PERIPHERAL;
+		else
+			state = OTG_STATE_A_HOST;
+	} else {
+		state = OTG_STATE_A_HOST;
+	}
+
+	if (priv->state != state) {
+		hi6220_start_peripheral(priv, state == OTG_STATE_B_PERIPHERAL);
+		priv->state = state;
+	}
+}
+
+static irqreturn_t hiusb_gpio_intr(int irq, void *data)
+{
+	struct hi6220_priv *priv = (struct hi6220_priv *)data;
+
+	/* add debounce time */
+	schedule_delayed_work(&priv->work, msecs_to_jiffies(100));

this is really bad. We have threaded interrupt support, right ?

Since we use two gpio to distinguish gadget mode or host mode.
Debounce time can introduce more accuracy.
I think threaded interrupt can not be used for adding debounce time.
Here add debounce is just for safety.

Thanks