[PATCH v11 2/9] ARM: l2c: use l2c_write_sec() for restoring latency and filter regs
From: m.szyprowski@samsung.com (Marek Szyprowski)
Date: 2015-01-05 12:19:27
Also in:
linux-omap, linux-samsung-soc, lkml
Subsystem:
arm port, the rest · Maintainers:
Russell King, Linus Torvalds
All four register for latency and filter settings cannot be written in non-secure mode and they should go through l2c_write_sec(). More on this can be found in CoreLink Level 2 Cache Controller L2C-310 Technical Reference Manual, 3.2. Register summary, table 3.1. This have been checked the TRM for r3p3, but it should be uniform for all revisions. Reported-by: Nishanth Menon <nm@ti.com> Suggested-by: Tomasz Figa <redacted> Signed-off-by: Marek Szyprowski <m.szyprowski@samsung.com> --- arch/arm/mm/cache-l2x0.c | 16 ++++++++-------- 1 file changed, 8 insertions(+), 8 deletions(-)
diff --git a/arch/arm/mm/cache-l2x0.c b/arch/arm/mm/cache-l2x0.c
index 5e65ca8dea62..0aeeaa95c42d 100644
--- a/arch/arm/mm/cache-l2x0.c
+++ b/arch/arm/mm/cache-l2x0.c@@ -623,14 +623,14 @@ static void l2c310_resume(void) unsigned revision; /* restore pl310 setup */ - writel_relaxed(l2x0_saved_regs.tag_latency, - base + L310_TAG_LATENCY_CTRL); - writel_relaxed(l2x0_saved_regs.data_latency, - base + L310_DATA_LATENCY_CTRL); - writel_relaxed(l2x0_saved_regs.filter_end, - base + L310_ADDR_FILTER_END); - writel_relaxed(l2x0_saved_regs.filter_start, - base + L310_ADDR_FILTER_START); + l2c_write_sec(l2x0_saved_regs.tag_latency, base, + L310_TAG_LATENCY_CTRL); + l2c_write_sec(l2x0_saved_regs.data_latency, base, + L310_DATA_LATENCY_CTRL); + l2c_write_sec(l2x0_saved_regs.filter_end, base, + L310_ADDR_FILTER_END); + l2c_write_sec(l2x0_saved_regs.filter_start, base, + L310_ADDR_FILTER_START); revision = readl_relaxed(base + L2X0_CACHE_ID) & L2X0_CACHE_ID_RTL_MASK;
--
1.9.2