[PATCH v3 1/8] of: Add NVIDIA Tegra SATA controller binding
From: mperttunen@nvidia.com (Mikko Perttunen)
Date: 2014-07-16 11:42:57
Also in:
linux-ide, linux-tegra, lkml
Thanks for you comment. I decided to keep the format as is for now, however, to keep a consistent style between all binding files describing Tegra hardware. Mikko On 16/07/14 12:26, Varka Bhadram wrote:
On 07/16/2014 02:24 PM, Mikko Perttunen wrote:quoted
This patch adds device tree binding documentation for the SATA controller found on NVIDIA Tegra SoCs. Signed-off-by: Mikko Perttunen <mperttunen@nvidia.com> --- .../devicetree/bindings/ata/tegra-sata.txt | 30 ++++++++++++++++++++++ 1 file changed, 30 insertions(+) create mode 100644 Documentation/devicetree/bindings/ata/tegra-sata.txtdiff --git a/Documentation/devicetree/bindings/ata/tegra-sata.txt b/Documentation/devicetree/bindings/ata/tegra-sata.txt new file mode 100644 index 0000000..946f207 --- /dev/null +++ b/Documentation/devicetree/bindings/ata/tegra-sata.txt@@ -0,0 +1,30 @@ +Tegra124 SoC SATA AHCI controller + +Required properties : +- compatible : "nvidia,tegra124-ahci". +- reg : Should contain 2 entries: + - AHCI register set (SATA BAR5) + - SATA register set +- interrupts : Defines the interrupt used by SATA +- clocks : Must contain an entry for each entry in clock-names. + See ../clocks/clock-bindings.txt for details. +- clock-names : Must include the following entries: + - sata + - sata-oob + - cml1 + - pll_eIt would be more readable if it like this... Required properties : - compatible : "nvidia,tegra124-ahci". - reg : Should contain 2 entries: - AHCI register set (SATA BAR5) - SATA register set - interrupts : Defines the interrupt used by SATA - clocks : Must contain an entry for each entry in clock-names. See ../clocks/clock-bindings.txt for details. ....quoted
+- resets : Must contain an entry for each entry in reset-names. + See ../reset/reset.txt for details. +- reset-names : Must include the following entries: + - sata + - sata-oob + - sata-cold +- phys : Must contain an entry for each entry in phy-names. + See ../phy/phy-bindings.txt for details. +- phy-names : Must include the following entries: + - sata-phy : XUSB PADCTL SATA PHY +- hvdd-supply : Defines the SATA HVDD regulator +- vddio-supply : Defines the SATA VDDIO regulator +- avdd-supply : Defines the SATA AVDD regulator +- target-5v-supply : Defines the SATA 5V power regulator +- target-12v-supply : Defines the SATA 12V power regulatorSame....