[PATCH v3 3/8] ARM: tegra: Add SATA and SATA power to Jetson TK1 device tree
From: mperttunen@nvidia.com (Mikko Perttunen)
Date: 2014-07-16 08:55:42
Also in:
linux-ide, linux-tegra, lkml
Subsystem:
the rest · Maintainer:
Linus Torvalds
This enables the integrated SATA controller on the Tegra124 system-on-chip on the Jetson TK1 board and adds regulators for the onboard Molex connector commonly used to power SATA devices. The regulators are marked always-on since they can be used for other purposes than powering SATA devices. Signed-off-by: Mikko Perttunen <mperttunen@nvidia.com> --- arch/arm/boot/dts/tegra124-jetson-tk1.dts | 35 +++++++++++++++++++++++++++++++ 1 file changed, 35 insertions(+)
diff --git a/arch/arm/boot/dts/tegra124-jetson-tk1.dts b/arch/arm/boot/dts/tegra124-jetson-tk1.dts
index 624b0fb..a4221e2 100644
--- a/arch/arm/boot/dts/tegra124-jetson-tk1.dts
+++ b/arch/arm/boot/dts/tegra124-jetson-tk1.dts@@ -1687,6 +1687,18 @@ vbus-supply = <&vdd_usb3_vbus>; }; + /* Serial ATA */ + sata at 0,70020000 { + status = "okay"; + + hvdd-supply = <&vdd_3v3_lp0>; + vddio-supply = <&vdd_1v05_run>; + avdd-supply = <&vdd_1v05_run>; + + target-5v-supply = <&vdd_5v0_sata>; + target-12v-supply = <&vdd_12v0_sata>; + }; + clocks { compatible = "simple-bus"; #address-cells = <1>;
@@ -1828,6 +1840,29 @@ enable-active-high; vin-supply = <&vdd_5v0_sys>; }; + + /* Molex power connector */ + vdd_5v0_sata: regulator at 13 { + compatible = "regulator-fixed"; + reg = <13>; + regulator-name = "+5V_SATA"; + regulator-min-microvolt = <5000000>; + regulator-max-microvolt = <5000000>; + gpio = <&gpio TEGRA_GPIO(EE, 2) GPIO_ACTIVE_HIGH>; + enable-active-high; + vin-supply = <&vdd_5v0_sys>; + }; + + vdd_12v0_sata: regulator at 14 { + compatible = "regulator-fixed"; + reg = <14>; + regulator-name = "+12V_SATA"; + regulator-min-microvolt = <12000000>; + regulator-max-microvolt = <12000000>; + gpio = <&gpio TEGRA_GPIO(EE, 2) GPIO_ACTIVE_HIGH>; + enable-active-high; + vin-supply = <&vdd_mux>; + }; }; sound {
--
1.8.1.5