[PATCH v9 6/7] ARM: berlin: add the AHCI node for the BG2Q
From: Antoine Ténart <hidden>
Date: 2014-07-07 10:16:55
Also in:
linux-devicetree, linux-ide, lkml
Subsystem:
the rest · Maintainer:
Linus Torvalds
The BG2Q has an AHCI SATA controller. Add the corresponding nodes (AHCI, PHY) into its device tree. Signed-off-by: Antoine T?nart <redacted> --- arch/arm/boot/dts/berlin2q.dtsi | 39 +++++++++++++++++++++++++++++++++++++++ 1 file changed, 39 insertions(+)
diff --git a/arch/arm/boot/dts/berlin2q.dtsi b/arch/arm/boot/dts/berlin2q.dtsi
index 635a16a64cb4..fa34ae6657ac 100644
--- a/arch/arm/boot/dts/berlin2q.dtsi
+++ b/arch/arm/boot/dts/berlin2q.dtsi@@ -303,6 +303,45 @@ clock-names = "refclk"; }; + ahci: sata at e90000 { + compatible = "generic-ahci"; + reg = <0xe90000 0x1000>; + interrupts = <GIC_SPI 7 IRQ_TYPE_LEVEL_HIGH>; + clocks = <&chip CLKID_SATA>; + #address-cells = <1>; + #size-cells = <0>; + + sata0: sata-port at 0 { + reg = <0>; + phys = <&sata_phy 0>; + status = "disabled"; + }; + + sata1: sata-port at 1 { + reg = <1>; + phys = <&sata_phy 1>; + status = "disabled"; + }; + }; + + sata_phy: phy at e900a0 { + compatible = "marvell,berlin2q-sata-phy"; + reg = <0xe900a0 0x200>; + clocks = <&chip CLKID_SATA>; + #address-cells = <1>; + #size-cells = <0>; + #phy-cells = <1>; + status = "disabled"; + + sata-phy at 0 { + reg = <0>; + }; + + sata-phy at 1 { + reg = <1>; + }; + }; + apb at fc0000 { compatible = "simple-bus"; #address-cells = <1>;
--
1.9.1