On Fri, Jun 13, 2014 at 09:23:28AM +0200, Peter De Schrijver wrote:

On Fri, Jun 13, 2014 at 12:17:02AM +0200, Stephen Warren wrote:

quoted

On 06/12/2014 09:36 AM, Peter De Schrijver wrote:

quoted

This driver allows userspace to read the raw efuse data. Its userspace
interface is modelled after the sunxi_sid driver which provides similar
functionality for some Allwinner SoCs. It has been tested on
Tegra20 (ventana), Tegra30 (beaverboard), Tegra114 (dalmore) and
Tegra124 (jetson TK1).

I think this series looks OK now. However, I noticed one change in
behaviour that I don't think is expected:

The current code/DTB print:
Tegra Revision: A01 SKU: 0 CPU Process: 0 Core Process: 0

However, applying these patches and booting yields:
Tegra Revision: A01 SKU: 0 CPU Process: 1 Core Process: 1

On which board/SoC?

I'm guessing you're running on Tegra124 because the silicon revision reported
is A01. If this is correct then, the current output is bogus. The current fuse
code does not have any Tegra124 support and will fall back to reading the same
fuse bits as on Tegra20 to determine the process IDs. You should get a warning
message though: 'Tegra: unknown chip id'

Cheers,

Peter.