[PATCH RESEND v4 21/37] mtd: st_spi_fsm: Update the flash Volatile Configuration Register
From: Lee Jones <hidden>
Date: 2014-01-23 10:38:39
Also in:
lkml
Subsystem:
memory technology devices (mtd), the rest · Maintainers:
Miquel Raynal, Richard Weinberger, Vignesh Raghavendra, Linus Torvalds
The FSM Serial Flash Controller is driven by issuing a standard set of register writes we call a message sequence. This patch supplies a method to prepare the message sequence responsible for updating a chip's VCR. Signed-off-by: Lee Jones <redacted> --- drivers/mtd/devices/st_spi_fsm.c | 32 ++++++++++++++++++++++++++++++++ 1 file changed, 32 insertions(+)
diff --git a/drivers/mtd/devices/st_spi_fsm.c b/drivers/mtd/devices/st_spi_fsm.c
index e74513d..d009e1b 100644
--- a/drivers/mtd/devices/st_spi_fsm.c
+++ b/drivers/mtd/devices/st_spi_fsm.c@@ -451,6 +451,23 @@ static struct stfsm_seq stfsm_seq_erase_sector = { SEQ_CFG_STARTSEQ), }; +static struct stfsm_seq stfsm_seq_wrvcr = { + .seq_opc[0] = (SEQ_OPC_PADS_1 | SEQ_OPC_CYCLES(8) | + SEQ_OPC_OPCODE(FLASH_CMD_WREN) | SEQ_OPC_CSDEASSERT), + .seq_opc[1] = (SEQ_OPC_PADS_1 | SEQ_OPC_CYCLES(8) | + SEQ_OPC_OPCODE(FLASH_CMD_WRVCR)), + .seq = { + STFSM_INST_CMD1, + STFSM_INST_CMD2, + STFSM_INST_STA_WR1, + STFSM_INST_STOP, + }, + .seq_cfg = (SEQ_CFG_PADS_1 | + SEQ_CFG_READNOTWRITE | + SEQ_CFG_CSDEASSERT | + SEQ_CFG_STARTSEQ), +}; + static int stfsm_n25q_en_32bit_addr_seq(struct stfsm_seq *seq) { seq->seq_opc[0] = (SEQ_OPC_PADS_1 | SEQ_OPC_CYCLES(8) |
@@ -573,6 +590,21 @@ static int stfsm_enter_32bit_addr(struct stfsm *fsm, int enter) return 0; } +static int stfsm_wrvcr(struct stfsm *fsm, uint8_t data) +{ + struct stfsm_seq *seq = &stfsm_seq_wrvcr; + + dev_dbg(fsm->dev, "writing VCR 0x%02x\n", data); + + seq->status = (STA_DATA_BYTE1(data) | STA_PADS_1 | STA_CSDEASSERT); + + stfsm_load_seq(fsm, seq); + + stfsm_wait_seq(fsm); + + return 0; +} + /* * SoC reset on 'boot-from-spi' systems *
--
1.8.3.2