Hello.

On 29-10-2013 13:52, Laurent Pinchart wrote:

quoted

quoted

Renesas ARM platforms are transitioning from single-platform to
multi-platform kernels using the new ARCH_SHMOBILE_MULTI. Make the
driver available on all ARM platforms to enable it on both ARCH_SHMOBILE
and ARCH_SHMOBILE_MULTI and increase build testing coverage.

quoted

quoted

Cc: Chris Ball <redacted>
Cc: Guennadi Liakhovetski <redacted>
Cc: Ian Molton <redacted>
Cc: linux-mmc at vger.kernel.org
Signed-off-by: Laurent Pinchart
[off-list ref]

[...]

quoted

quoted

diff --git a/drivers/mmc/host/tmio_mmc_dma.c

b/drivers/mmc/host/tmio_mmc_dma.c index 65edb4a..535bc35 100644

--- a/drivers/mmc/host/tmio_mmc_dma.c
+++ b/drivers/mmc/host/tmio_mmc_dma.c

@@ -28,7 +28,7 @@ void tmio_mmc_enable_dma(struct tmio_mmc_host *host,

bool enable)>
  	if (!host->chan_tx || !host->chan_rx)
  	
  		return;

-#if defined(CONFIG_SUPERH) || defined(CONFIG_ARCH_SHMOBILE)
+#if defined(CONFIG_SUPERH) || defined(CONFIG_ARM)

quoted

I'm not sure about this one. In principle DMA so far is only used on SDHI
with TMIO. But this #if was for a theoretical case, when a TMIO MMC IP
inside an MFD is also used with DMA. Bus since I had no indormation about
whether the CTL_DMA_ENABLE register was SDHI specific or not, I put it
under an #if for the time being. In any case, I don't think making it
#ifdef CONFIG_ARM makes much sense. We can either remove the #if
completely, or keep it to limit the scope of this write to sh-mobile
arches.

SUPERH || ARCH_SHMOBILE covers all the platforms this driver currently builds
on. Now that we're adding ARCH_SHMOBILE_MULTI the #if needs to cover that case
as well. I'm fine with limiting the CTL_DMA_ENABLE write to SUPERH only (which
would modify the driver's behaviour)

    I'm afraid that would break the driver's ability to work in DMA mode on 
SH-Mobile SoCs.

or enabling it unconditionally, but I
don't think adding a defined(CONFIG_ARCH_SHMOBILE_MULTI) to the above #if
makes sense, unless there's a plan to add support for DMA for non-SH
(including both SUPERH and ARCH_SHMOBILE) platforms.

    Not only the plan -- I have already posted the patches to do it for 
R8A777x, and Simon has queued them for 3.13.

quoted

quoted

  	/* Switch DMA mode on or off - SuperH specific? */
  	sd_ctrl_write16(host, CTL_DMA_ENABLE, enable ? 2 : 0);

  #endif

WBR, Sergei