[PATCH v3 6/7] ARM: kirkwood: add gigabit ethernet and mvmdio device tree nodes

On 05/20/2013 11:27 PM, Simon Baatz wrote:

Hi Sebastian,

On Mon, May 06, 2013 at 05:33:39PM +0200, Sebastian Hesselbarth wrote:

quoted

This patch adds mv643xx_eth and mvmdio device tree nodes for DT enabled
Kirkwood boards. Phy nodes are also added with reg property set on a
per-board basis.

...

quoted

diff --git a/arch/arm/boot/dts/kirkwood.dtsi b/arch/arm/boot/dts/kirkwood.dtsi
index fada7e6..c01a273 100644
--- a/arch/arm/boot/dts/kirkwood.dtsi
+++ b/arch/arm/boot/dts/kirkwood.dtsi

@@ -202,5 +202,57 @@
  			clocks =<&gate_clk 4>;
  			status = "disabled";
  		};
+
+		mdio: mdio-bus at 72004 {
+			compatible = "marvell,orion-mdio";
+			reg =<0x72004 0x84>;
+			interrupts =<11>;

Shouldn't this be 46?

Yes, mdio is using GbE0Err interrupt and that is 14 on IRQ HIGH CAUSE.
I was misled by 11 on IRQ LOW CAUSE.

Sebastian