The GPMC has various different configuration options such as bus-width,
synchronous or asychronous mode selection, burst mode options etc.
Currently, there is no common function for configuring these options and
various devices set these options by either programming the GPMC CONFIG1
register directly or by calling gpmc_cs_configure() to set some of the
options.

Add a new function for configuring all of the GPMC options. Having a common
function for configuring this options will simplify code and ease the
migration to device-tree.

Signed-off-by: Jon Hunter <redacted>
---
 arch/arm/mach-omap2/gpmc.c |   65 ++++++++++++++++++++++++++++++++++++++++++++
 arch/arm/mach-omap2/gpmc.h |    6 ++++
 2 files changed, 71 insertions(+)

diff --git a/arch/arm/mach-omap2/gpmc.c b/arch/arm/mach-omap2/gpmc.c
index 465cac9..fb8dfd2 100644
--- a/arch/arm/mach-omap2/gpmc.c
+++ b/arch/arm/mach-omap2/gpmc.c

@@ -1137,6 +1137,71 @@ int gpmc_calc_timings(struct gpmc_timings *gpmc_t,
 	return 0;
 }
 
+int gpmc_cs_program_settings(int cs, struct gpmc_settings *p)
+{
+	u32 config1;
+
+	if ((!p->device_width) || (p->device_width > GPMC_DEVWIDTH_16BIT)) {
+		pr_err("%s: invalid width %d!", __func__, p->device_width);
+		return -EINVAL;
+	}
+
+	/* Address-data multiplexing not supported for NAND devices */
+	if (p->device_nand && p->mux_add_data) {
+		pr_err("%s: invalid configuration!\n", __func__);
+		return -EINVAL;
+	}
+
+	/* Page/burst mode supports lengths of 4, 8 and 16 bytes */
+	if (p->burst_read || p->burst_write) {
+		switch (p->burst_len) {
+		case GPMC_BURST_4:
+		case GPMC_BURST_8:
+		case GPMC_BURST_16:
+			break;
+		default:
+			pr_err("%s: invalid page/burst-length (%d)\n",
+			       __func__, p->burst_len);
+			return -EINVAL;
+		}
+	}
+
+	if ((p->wait_on_read || p->wait_on_write) &&
+	    (p->wait_pin > gpmc_nr_waitpins)) {
+		pr_err("%s: invalid wait-pin (%d)\n", __func__, p->wait_pin);
+		return -EINVAL;
+	}
+
+	config1 = GPMC_CONFIG1_DEVICESIZE((p->device_width - 1));