-----Original Message-----
From: Richard Genoud [mailto:richard.genoud at gmail.com]
Sent: 2013?1?18? 16:46
To: Yang, Wenyou
Cc: linux-arm-kernel at lists.infradead.org; linux-kernel at vger.kernel.org; Ferre,
Nicolas; plagnioj at jcrosoft.com; Lin, JM
Subject: Re: [v4 PATCH 00/12] atmel spi controller with dmaengine and device
tree support

2013/1/14 Wenyou Yang [off-list ref]:

quoted

Hi All,

This set of patches is to add dmaengine and device tree support for atmel spi.
The work is based on Nicolas and Richard's work.
It is tested on at91sam9x5ek, at91sam9m10g45ek, at91sam9263ek and

at91sam9g20ek.

quoted

It is based on v3.8-rc3.

Hi,
You should rebase it on rc4 because __devinit macros are gone in rc4.
(cf 54b956b903607f8f8878754dd4352da6a54a1da2 )
So the patches 05 and 06 will break compilation.

thanks

quoted

Changelog:
v4:
        1./ Take Joe Perches's advance, rewrite atmel_spi_is_v2(struct

atmel_spi *as)

quoted

             and atmel_spi_use_dma(struct atmel_spi *as),
             and remove atmel_spi_use_pdc(struct atmel_spi *as).

        2./ Rebase on v3.8-rc3.

V3:
        1./ Rebase on v3.8-rc2.

        2./ Remove some Jean-Christophe's patches which has been
            applied on v3.8-rc2.

        3./ Remove spi property "cs-gpios" from the SoC dtsi files
            to the board dts files to avoid some useless pin conflicts.

v2:
        1./ Remove the patch :PATCH]mtd: m25p80: change the

m25p80_read to reading page to page

quoted

            which purpose to fix the BUG: when run "flashcp /bin/busybox

/dev/mtdX" in

quoted

            the at91sam9g25ek with DMA mode, it arises a OOPS.
            Now fix it in this patch:
            [PATHC] spi/atmel_spi: add dmaengine support changing to fix

the [BUG].

quoted

        2./ Remove two patches:
            which purpose to read dts property to select SPI IP version

and DMA mode

quoted

            Now they will be gat from device tree different compatile.

        3./ Fix DMA: when enable both spi0 AND spi1, the spi0 doesn't

work BUG.

quoted

        4./ Rebase v3.7-rc8.

Best Regards,
Wenyou Yang.

Nicolas Ferre (5):
  spi/atmel_spi: add physical base address
  spi/atmel_spi: call unmapping on transfers buffers
  spi/atmel_spi: status information passed through controller data
  spi/atmel_spi: add flag to controller data for lock operations
  spi/atmel_spi: add dmaengine support

Richard Genoud (6):
  spi/atmel_spi: fix spi-atmel driver to adapt to slave_config changes
  spi/atmel_spi: correct 16 bits transfers using PIO
  spi/atmel_spi: correct 16 bits transfer with DMA
  ARM: at91: add clocks for spi dt entries
  ARM: dts: add spi nodes for atmel SoC
  ARM: dts: add spi nodes for the atmel boards

Wenyou Yang (1):
  spi/atmel_spi: update the dt support

 arch/arm/boot/dts/at91sam9260.dtsi          |   18 +
 arch/arm/boot/dts/at91sam9263.dtsi          |   18 +
 arch/arm/boot/dts/at91sam9263ek.dts         |   14 +
 arch/arm/boot/dts/at91sam9g20ek_common.dtsi |   14 +
 arch/arm/boot/dts/at91sam9g45.dtsi          |   18 +
 arch/arm/boot/dts/at91sam9m10g45ek.dts      |   14 +
 arch/arm/boot/dts/at91sam9n12.dtsi          |   18 +
 arch/arm/boot/dts/at91sam9n12ek.dts         |   14 +
 arch/arm/boot/dts/at91sam9x5.dtsi           |   18 +
 arch/arm/boot/dts/at91sam9x5ek.dtsi         |   14 +
 arch/arm/mach-at91/at91sam9260.c            |    2 +
 arch/arm/mach-at91/at91sam9g45.c            |    2 +
 arch/arm/mach-at91/at91sam9n12.c            |    2 +
 arch/arm/mach-at91/at91sam9x5.c             |    2 +
 drivers/spi/spi-atmel.c                     |  809

++++++++++++++++++++++++---

quoted

 15 files changed, 908 insertions(+), 69 deletions(-)

--
1.7.9.5

--
for me, ck means con kolivas and not calvin klein... does it mean I'm a geek ?