[PATCH 1/4] drivers: create a pinmux subsystem

On Wed, May 4, 2011 at 12:22 PM, Tony Lindgren [off-list ref] wrote:

* Colin Cross [off-list ref] [110502 14:26]:

quoted

On Mon, May 2, 2011 at 1:52 PM, Stephen Warren [off-list ref] wrote:

* Drive strength is also controlled through groups of pins, but
different groups than pinmux. ?Most of the drive strength groups are
collections of pad mux groups, but there are a few pins that are in
the same pad mux group but a different drive strength group.
* Setting a pin as a GPIO overrides its group's mux setting, except
for the group's tristate. ?You must untristate the entire group to use
a single pin as a GPIO.
* Each group has a "safe mode", but which mux id to select to enter
the safe mode is completely random.

Just posted something in this thread regarding using standard data and
standard read and write functions, then allow setting platform specific
custom flags as needed. Care to see if that works for you too?

Tegra does not allow pin muxing on the pin by pin basis. And,
registers that define mux config differ from those that define flags
(pull, driver strength, safe mode etc).

quoted

In the end, we determined that there was no way to sanely handle
setting up Tegra's pinmux programatically, and instead required each
board to pass in a table of pinmux settings.

Eventually we should get the package specific table of available pins
and the board specific settings in devicetree data. And then it's
easy to set the pins as desired while being able to debug it.

Regards,

Tony
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo at vger.kernel.org
More majordomo info at ?http://vger.kernel.org/majordomo-info.html
Please read the FAQ at ?http://www.tux.org/lkml/

-- 
? ? Sincerely Yours,
? ? ? ? Mike.