[PATCH 1/8] macb: unify at91 and avr32 platform data

On 08:56 Fri 11 Mar     , Jamie Iles wrote:

On Fri, Mar 11, 2011 at 02:41:40AM +0100, Jean-Christophe PLAGNIOL-VILLARD wrote:

quoted

On 13:17 Thu 10 Mar     , Jamie Iles wrote:

quoted

On Thu, Mar 10, 2011 at 02:06:04PM +0100, Nicolas Ferre wrote:

quoted

On 3/10/2011 11:10 AM, Jamie Iles :

quoted

--- a/drivers/net/macb.c
+++ b/drivers/net/macb.c

@@ -18,12 +18,10 @@
 #include <linux/netdevice.h>
 #include <linux/etherdevice.h>
 #include <linux/dma-mapping.h>
+#include <linux/platform_data/macb.h>
 #include <linux/platform_device.h>
 #include <linux/phy.h>
 
-#include <mach/board.h>
-#include <mach/cpu.h>

I did not bouble check but do we need no more cpu_is_ macros?

No, I couldn't see any in there and it builds for all of the AT91 
targets and all of the AVR32 ones that I tried.  I can't see any macros 
in there that are likely to use cpu_is_* internally either.

keep as we need to remove the #ifdef AT91 to cpu_is

I've patch for this

Is this for the user IO register where the value written is conditional 
on both RMII/MII and arch type?

yes for 

#if defined(CONFIG_ARCH_AT91)
		macb_writel(bp, USRIO, (MACB_BIT(RMII) | MACB_BIT(CLKEN)));
#else
		macb_writel(bp, USRIO, 0);
#endif
	else
#if defined(CONFIG_ARCH_AT91)
		macb_writel(bp, USRIO, MACB_BIT(CLKEN));
#else
		macb_writel(bp, USRIO, MACB_BIT(MII));
#endif

Best Regards,
J.