[PATCH 3/8] macb: convert printk to pr_ and friends
flat view
STALE5700d
From: joe@perches.com (Joe Perches)
Date: 2011-03-10 22:48:04
Also in:
netdev
Revision v1 of 7 in this series.
On Thu, 2011-03-10 at 10:10 +0000, Jamie Iles wrote:
macb is already using the dev_dbg() and friends helpers so use pr_foo() along with a pr_fmt() definition to make the printing a little cleaner. Signed-off-by: Jamie Iles <redacted>
Hi Jamie. Because these conversions use a struct net_device, they would be better as: netdev_<foo>(struct net_device *dev, const char *fmt, ...)
quoted hunk ↗ jump to hunk
diff --git a/drivers/net/macb.c b/drivers/net/macb.c@@ -175,11 +176,11 @@ static void macb_handle_link_change(struct net_device *dev) if (status_change) { if (phydev->link) - printk(KERN_INFO "%s: link up (%d/%s)\n", + pr_info("%s: link up (%d/%s)\n", dev->name, phydev->speed, DUPLEX_FULL == phydev->duplex ? "Full":"Half");
netdev_info(dev, "link up (%d/%s)\n", phydev->speed, phydev->duplex == DUPLEX_FULL ? "Full" : "Half");
quoted hunk ↗ jump to hunk
else - printk(KERN_INFO "%s: link down\n", dev->name); + pr_info("%s: link down\n", dev->name);
netdev_info(dev, "link down\n");
quoted hunk ↗ jump to hunk
@@ -193,7 +194,7 @@ static int macb_mii_probe(struct net_device *dev) phydev = phy_find_first(bp->mii_bus); if (!phydev) { - printk (KERN_ERR "%s: no PHY found\n", dev->name); + pr_err("%s: no PHY found\n", dev->name);
netdev_err(dev, "no PHY found\n");
quoted hunk ↗ jump to hunk
@@ -206,7 +207,7 @@ static int macb_mii_probe(struct net_device *dev) PHY_INTERFACE_MODE_RMII : PHY_INTERFACE_MODE_MII); if (ret) { - printk(KERN_ERR "%s: Could not attach to PHY\n", dev->name); + pr_err("%s: Could not attach to PHY\n", dev->name);
netdev_err(dev, "could not attach to PHY\n"); etc...