[RFC][PATCH] signal/m68k: Use force_sigsegv(SIGSEGV) in fpsp040_die

In the fpsp040 code when copyin or copyout fails call
force_sigsegv(SIGSEGV) instead of do_exit(SIGSEGV).

This solves a couple of problems.  Because do_exit embeds the ptrace
stop PTRACE_EVENT_EXIT a complete stack frame needs to be present for
that to work correctly.  There is always the information needed for a
ptrace stop where get_signal is called.  So exiting with a signal
solves the ptrace issue.

Further exiting with a signal ensures that all of the threads in a
process are killed not just the thread that malfunctioned.  Which
avoids confusing userspace.

To make force_sigsegv(SIGSEGV) work in fpsp040_die modify the code to
save all of the registers and jump to ret_from_exception (which
ultimately calls get_signal) after fpsp040_die returns.

Signed-off-by: "Eric W. Biederman" <redacted>
---

Can someone please check my m68k assembly changes?

I think I have them correct, and the code assembles but I don't
understand the fine points of when the different branch instructions
should be used.

 arch/m68k/fpsp040/skeleton.S | 3 ++-
 arch/m68k/kernel/traps.c     | 2 +-
 2 files changed, 3 insertions(+), 2 deletions(-)

diff --git a/arch/m68k/fpsp040/skeleton.S b/arch/m68k/fpsp040/skeleton.S
index a8f41615d94a..ec767523c012 100644
--- a/arch/m68k/fpsp040/skeleton.S
+++ b/arch/m68k/fpsp040/skeleton.S

@@ -502,7 +502,8 @@ in_ea:
 	.section .fixup,#alloc,#execinstr
 	.even
 1:
-	jbra	fpsp040_die
+	bsrl	fpsp040_die
+	jmp	.Lnotkern
 
 	.section __ex_table,#alloc
 	.align	4

diff --git a/arch/m68k/kernel/traps.c b/arch/m68k/kernel/traps.c
index 9e1261462bcc..5b19fcdcd69e 100644
--- a/arch/m68k/kernel/traps.c
+++ b/arch/m68k/kernel/traps.c

@@ -1150,7 +1150,7 @@ asmlinkage void set_esp0(unsigned long ssp)
  */
 asmlinkage void fpsp040_die(void)
 {
-	do_exit(SIGSEGV);
+	force_sigsegv(SIGSEGV);
 }
 
 #ifdef CONFIG_M68KFPU_EMU

-- 
2.20.1