Hi,

I recently ran into a pretty serious issue due to the Unix/Linux (mis)behavior
of forcing DTR and RTS asserted when a serial port is set, losing the
pre-existing status in the process. Since it is impossible probe for the
current status or even if it is a functional serial port without a file
descriptor, this is very problematic. This came up in the context of probing
for serial ports from an application, so even if termios could be modified
without a file descriptor (which it can't) it would not be safe.

I noted there was a patchset for that on linux-serial from 2022 which
apparently got dropped and never merged, but I think it has a pretty serious
problem: it used a sysfs setting to control the behavior, which may be
reasonable for a default, but at the end of it this is really something that
is determined by the intent of the open() call, just like O_NONBLOCK replaced
the old callout devices we once had.

It seems to me that this may very well be a problem beyond ttys, in which case
a new open flag to request to a driver that the configuration and (observable)
state of the underlying hardware device -- whatever it may be -- should not be
disturbed by calling open(). This is of course already the case for many
devices, not to mention block and non-devices, in which case this flag is a
don't care.

The best name I came up with was O_NRESETDEV, but it's not something I'm
particularly attached to.

If the opinion is that this *doesn't* have a scope beyond ttys, then perhaps
abusing the O_DIRECT flag for this purpose would be an alternative.

Thoughts?

	-hpa