Hi Thomas,
<snip>

2016-06-16 15:32, Bruce Richardson:

quoted

On Mon, Jun 13, 2016 at 01:28:08PM +0100, Iremonger, Bernard wrote:

quoted

quoted

Why does this particular PMD need spinlocks when doing RX and TX,
while other device types do not? How is adding/removing devices
from a bonded device different to other control operations that
can be done on physical PMDs? Is this not similar to say bringing
down or hotplugging out a physical port just before an RX or TX

operation takes place?

quoted

quoted

quoted

For all other PMDs we rely on the app to synchronise control and
data plane operation - why not here?

/Bruce

This issue arose during VM live migration testing.
For VM live migration it is necessary (while traffic is running) to be able to

remove a bonded slave device, stop it, close it and detach it.

quoted

quoted

It a slave device is removed from a bonded device while traffic is running

a segmentation fault may occur in the rx/tx burst function. The spinlock has
been added to prevent this occurring.

quoted

quoted

The bonding device already uses a spinlock to synchronise between the

add and remove functionality and the slave_link_status_change_monitor
code.

quoted

quoted

Previously testpmd did not allow, stop, close or detach of PMD while
traffic was running. Testpmd has been modified with the following
patchset

http://dpdk.org/dev/patchwork/patch/13472/

It now allows stop, close and detach of a PMD provided in it is not

forwarding and is not a slave of bonded PMD.

quoted

quoted

I will admit to not being fully convinced, but if nobody else has any
serious objections, and since this patch has been reviewed and acked,
I'm ok to merge it in. I'll do so shortly.

Please hold on.
Seeing locks introduced in the Rx/Tx path is an alert.
We clearly need a design document to explain where locks can be used and
what are the responsibility of the control plane.
If everybody agrees in this document that DPDK can have some locks in the
fast path, then OK to merge it.

So I would say NACK for 16.07 and maybe postpone to 16.11.

Looking at the documentation for the bonding PMD.

http://dpdk.org/doc/guides/prog_guide/link_bonding_poll_mode_drv_lib.html

In section 10.2 it states the following:

Bonded devices support the dynamical addition and removal of slave devices using the rte_eth_bond_slave_add / rte_eth_bond_slave_remove APIs.

If a slave device is added or removed while traffic is running, there is the possibility of a segmentation fault in the rx/tx burst functions. This is most likely to occur in the round robin bonding mode.

This patch set fixes what appears to be a bug in the bonding PMD.

Performance measurements have been made with this patch set applied and without the patches applied using 64 byte packets. 

With the patches applied the following drop in performance was observed:

% drop for fwd+io:	0.16%
% drop for fwd+mac:	0.39%

This patch set has been reviewed and ack'ed, so I think it should be applied in 16.07

Regards,

Bernard.