From: Marc Zyngier <redacted>
This patch has been added to the 3.18 stable tree. If you have any
objections, please let us know.
===============
[ Upstream commit 7c9b973061b03af62734f613f6abec46c0dd4a88 ]
The GICv3 driver wrongly assumes that it runs on the non-secure
side of a secure-enabled system, while it could be on a system
with a single security state, or a GICv3 with GICD_CTLR.DS set.
Either way, it is important to configure this properly, or
interrupts will simply not be delivered on this HW.
Cc: stable@vger.kernel.org
Reported-by: Peter Maydell <redacted>
Tested-by: Peter Maydell <redacted>
Signed-off-by: Marc Zyngier <redacted>
Signed-off-by: Sasha Levin <redacted>
---
drivers/irqchip/irq-gic-v3.c | 12 ++++++++++++
1 file changed, 12 insertions(+)
diff --git a/drivers/irqchip/irq-gic-v3.c b/drivers/irqchip/irq-gic-v3.c
index a94342f..8362bed 100644
--- a/drivers/irqchip/irq-gic-v3.c
+++ b/drivers/irqchip/irq-gic-v3.c
@@ -309,6 +309,15 @@ static void __init gic_dist_init(void)
writel_relaxed(0, base + GICD_CTLR);
gic_dist_wait_for_rwp();
+ /*
+ * Configure SPIs as non-secure Group-1. This will only matter
+ * if the GIC only has a single security state. This will not
+ * do the right thing if the kernel is running in secure mode,
+ * but that's not the intended use case anyway.
+ */
+ for (i = 32; i < gic_data.irq_nr; i += 32)
+ writel_relaxed(~0, base + GICD_IGROUPR + i / 8);
+
gic_dist_config(base, gic_data.irq_nr, gic_dist_wait_for_rwp);
/* Enable distributor with ARE, Group1 */
@@ -404,6 +413,9 @@ static void gic_cpu_init(void)
rbase = gic_data_rdist_sgi_base();
+ /* Configure SGIs/PPIs as non-secure Group-1 */
+ writel_relaxed(~0, rbase + GICR_IGROUPR0);
+
gic_cpu_config(rbase, gic_redist_wait_for_rwp);
/* initialise system registers */
--
2.5.0