[PATCH net-next 04/11] docs: networking: Document IPQ5424 as a supported SoC

From
Luo Jie <jie.luo@oss.qualcomm.com>
Date
2026-10-08 14:51:49
Also in
linux-arm-msm, linux-devicetree, linux-doc, lkml
Reply to
Luo Jie, 2026-10-08
Update the qualcomm PPE driver documentation to list IPQ5424 among the
supported SoCs, and describe the per-SoC PPE hardware differences.

The IPQ5424 PPE reuses the same switch core as IPQ9574, but runs at a clock
rate of 375 MHz and supports only 3 front panel ports along with the EDMA
FIFO port for host CPU communication. The EIP FIFO port is not available on
IPQ5424.

Signed-off-by: Luo Jie <jie.luo@oss.qualcomm.com>
---
 .../networking/device_drivers/ethernet/qualcomm/ppe/ppe.rst       | 8 ++++++++
 1 file changed, 8 insertions(+)
diff --git a/Documentation/networking/device_drivers/ethernet/qualcomm/ppe/ppe.rst b/Documentation/networking/device_drivers/ethernet/qualcomm/ppe/ppe.rst
index 4ab299a28969..04c48cec66d5 100644
--- a/Documentation/networking/device_drivers/ethernet/qualcomm/ppe/ppe.rst
+++ b/Documentation/networking/device_drivers/ethernet/qualcomm/ppe/ppe.rst
@@ -167,6 +167,14 @@ PPE Driver Supported SoCs
 The PPE driver supports the following IPQ SoC:
 
 - IPQ9574
+    The PPE runs at a clock rate of 353 MHz. The switch core has 6 front panel
+    ports (port1 to port6) and two FIFO interfaces: the EDMA FIFO (port0) for
+    the host CPU communication and the EIP FIFO (port7) for the EIP engine.
+- IPQ5424
+    The PPE reuses the same switch core as IPQ9574 and runs at a clock rate of
+    375 MHz. It supports 3 front panel ports (port1 to port3) with MAC0 to MAC2,
+    and only the EDMA FIFO interface (port0) for the host CPU communication. The
+    EIP FIFO and port4 to port6 are not available.
 
 
 Enabling the Driver
-- 
2.43.0
Thread (24 messages) 24 messages, 5 authors, last reply 2026-10-12
Keyboard shortcuts
hback out one level
jnext message in thread / next series-diff position
kprevious message in thread / previous series-diff position
ldrill in
Escclose help / fold thread tree
?toggle this help