Re: [PATCH v2] Add config phase for dp83td510e phy

On Tue, Sep 08, 2026 at 10:08:43AM +0000, Julien Blanc wrote:

Add a config phase for the Texas Instruments DP83TD510E ethenet PHY

The config phase currently sets the following properties from the
device tree:
  * RMII / RGMII mode (note : RMII master / slave can only be set
    by straps and cannot be changed at runtime)
  * RGMII delays. These delays can be enabled on the phy side, only
    as a boolean. Delays are enabled if phy-mode is rgmii-id, or
    rgmii-[rx|tx]id which enables only the corresponding delay.

Signed-off-by: Julien Blanc <redacted>

Reviewed-by: Andrew Lunn <andrew@lunn.ch>

    Andrew