[PATCH net-next v3 05/13] net: ethernet: oa_tc6: Export standard defined registers
From: Ciprian Regus via B4 Relay <devnull+ciprian.regus.analog.com@kernel.org>
Date: 2026-06-04 16:33:00
Also in:
b4-sent, linux-devicetree, linux-doc, lkml
Subsystem:
networking drivers, open alliance 10base-t1s macphy serial interface framework, the rest · Maintainers:
Andrew Lunn, "David S. Miller", Eric Dumazet, Jakub Kicinski, Paolo Abeni, Parthiban Veerasooran, Linus Torvalds
From: Ciprian Regus <redacted> Move defines for standard Open Alliance TC6 register addresses and subfields in the oa_tc6's header and add entries for the PHYID and CONFIG2. As such, other ethernet drivers that rely on oa_tc6 can use them directly. Signed-off-by: Ciprian Regus <redacted> --- v3 changelog: - Only move the register definitions, without adding the OA_TC6_ prefix v2 changelog: - New patch --- drivers/net/ethernet/oa_tc6.c | 48 ------------------------------------------- include/linux/oa_tc6.h | 48 +++++++++++++++++++++++++++++++++++++++++++ 2 files changed, 48 insertions(+), 48 deletions(-)
diff --git a/drivers/net/ethernet/oa_tc6.c b/drivers/net/ethernet/oa_tc6.c
index b37e398e30e3..97df38207827 100644
--- a/drivers/net/ethernet/oa_tc6.c
+++ b/drivers/net/ethernet/oa_tc6.c@@ -11,45 +11,6 @@ #include <linux/phy.h> #include <linux/oa_tc6.h> -/* OPEN Alliance TC6 registers */ -/* Standard Capabilities Register */ -#define OA_TC6_REG_STDCAP 0x0002 -#define STDCAP_DIRECT_PHY_REG_ACCESS BIT(8) - -/* Reset Control and Status Register */ -#define OA_TC6_REG_RESET 0x0003 -#define RESET_SWRESET BIT(0) /* Software Reset */ - -/* Configuration Register #0 */ -#define OA_TC6_REG_CONFIG0 0x0004 -#define CONFIG0_SYNC BIT(15) -#define CONFIG0_ZARFE_ENABLE BIT(12) -#define CONFIG0_PROTE BIT(5) - -/* Status Register #0 */ -#define OA_TC6_REG_STATUS0 0x0008 -#define STATUS0_RESETC BIT(6) /* Reset Complete */ -#define STATUS0_HEADER_ERROR BIT(5) -#define STATUS0_LOSS_OF_FRAME_ERROR BIT(4) -#define STATUS0_RX_BUFFER_OVERFLOW_ERROR BIT(3) -#define STATUS0_TX_PROTOCOL_ERROR BIT(0) - -/* Buffer Status Register */ -#define OA_TC6_REG_BUFFER_STATUS 0x000B -#define BUFFER_STATUS_TX_CREDITS_AVAILABLE GENMASK(15, 8) -#define BUFFER_STATUS_RX_CHUNKS_AVAILABLE GENMASK(7, 0) - -/* Interrupt Mask Register #0 */ -#define OA_TC6_REG_INT_MASK0 0x000C -#define INT_MASK0_HEADER_ERR_MASK BIT(5) -#define INT_MASK0_LOSS_OF_FRAME_ERR_MASK BIT(4) -#define INT_MASK0_RX_BUFFER_OVERFLOW_ERR_MASK BIT(3) -#define INT_MASK0_TX_PROTOCOL_ERR_MASK BIT(0) - -/* PHY Clause 22 registers base address and mask */ -#define OA_TC6_PHY_STD_REG_ADDR_BASE 0xFF00 -#define OA_TC6_PHY_STD_REG_ADDR_MASK 0x1F - /* Control command header */ #define OA_TC6_CTRL_HEADER_DATA_NOT_CTRL BIT(31) #define OA_TC6_CTRL_HEADER_WRITE_NOT_READ BIT(29)
@@ -79,15 +40,6 @@ #define OA_TC6_DATA_FOOTER_END_BYTE_OFFSET GENMASK(13, 8) #define OA_TC6_DATA_FOOTER_TX_CREDITS GENMASK(5, 1) -/* PHY – Clause 45 registers memory map selector (MMS) as per table 6 in the - * OPEN Alliance specification. - */ -#define OA_TC6_PHY_C45_PCS_MMS2 2 /* MMD 3 */ -#define OA_TC6_PHY_C45_PMA_PMD_MMS3 3 /* MMD 1 */ -#define OA_TC6_PHY_C45_VS_PLCA_MMS4 4 /* MMD 31 */ -#define OA_TC6_PHY_C45_AUTO_NEG_MMS5 5 /* MMD 7 */ -#define OA_TC6_PHY_C45_POWER_UNIT_MMS6 6 /* MMD 13 */ - #define OA_TC6_CTRL_PROT_REPLY_SIZE 4 #define OA_TC6_CTRL_HEADER_SIZE 4 #define OA_TC6_CTRL_REG_VALUE_SIZE 4
diff --git a/include/linux/oa_tc6.h b/include/linux/oa_tc6.h
index 2660eefa3504..bbc42758a313 100644
--- a/include/linux/oa_tc6.h
+++ b/include/linux/oa_tc6.h@@ -10,6 +10,54 @@ #include <linux/etherdevice.h> #include <linux/spi/spi.h> +/* OPEN Alliance TC6 registers */ +/* Standard Capabilities Register */ +#define OA_TC6_REG_STDCAP 0x0002 +#define STDCAP_DIRECT_PHY_REG_ACCESS BIT(8) + +/* Reset Control and Status Register */ +#define OA_TC6_REG_RESET 0x0003 +#define RESET_SWRESET BIT(0) /* Software Reset */ + +/* Configuration Register #0 */ +#define OA_TC6_REG_CONFIG0 0x0004 +#define CONFIG0_SYNC BIT(15) +#define CONFIG0_ZARFE_ENABLE BIT(12) +#define CONFIG0_PROTE BIT(5) + +/* Status Register #0 */ +#define OA_TC6_REG_STATUS0 0x0008 +#define STATUS0_RESETC BIT(6) /* Reset Complete */ +#define STATUS0_HEADER_ERROR BIT(5) +#define STATUS0_LOSS_OF_FRAME_ERROR BIT(4) +#define STATUS0_RX_BUFFER_OVERFLOW_ERROR BIT(3) +#define STATUS0_TX_PROTOCOL_ERROR BIT(0) + +/* Buffer Status Register */ +#define OA_TC6_REG_BUFFER_STATUS 0x000B +#define BUFFER_STATUS_TX_CREDITS_AVAILABLE GENMASK(15, 8) +#define BUFFER_STATUS_RX_CHUNKS_AVAILABLE GENMASK(7, 0) + +/* Interrupt Mask Register #0 */ +#define OA_TC6_REG_INT_MASK0 0x000C +#define INT_MASK0_HEADER_ERR_MASK BIT(5) +#define INT_MASK0_LOSS_OF_FRAME_ERR_MASK BIT(4) +#define INT_MASK0_RX_BUFFER_OVERFLOW_ERR_MASK BIT(3) +#define INT_MASK0_TX_PROTOCOL_ERR_MASK BIT(0) + +/* PHY Clause 22 registers base address and mask */ +#define OA_TC6_PHY_STD_REG_ADDR_BASE 0xFF00 +#define OA_TC6_PHY_STD_REG_ADDR_MASK 0x1F + +/* PHY – Clause 45 registers memory map selector (MMS) as per table 6 in the + * OPEN Alliance specification. + */ +#define OA_TC6_PHY_C45_PCS_MMS2 2 /* MMD 3 */ +#define OA_TC6_PHY_C45_PMA_PMD_MMS3 3 /* MMD 1 */ +#define OA_TC6_PHY_C45_VS_PLCA_MMS4 4 /* MMD 31 */ +#define OA_TC6_PHY_C45_AUTO_NEG_MMS5 5 /* MMD 7 */ +#define OA_TC6_PHY_C45_POWER_UNIT_MMS6 6 /* MMD 13 */ + struct oa_tc6; enum oa_tc6_quirk_flag {
--
2.43.0