Re: [PATCH 4/5] docs: fix repeated prepositions across documentation

Signed-off-by: Adrien Reynard <redacted>
---
  Documentation/dev-tools/kasan.rst                   | 2 +-
  Documentation/networking/switchdev.rst              | 2 +-
  Documentation/virt/uml/user_mode_linux_howto_v2.rst | 2 +-
  3 files changed, 3 insertions(+), 3 deletions(-)

diff --git a/Documentation/dev-tools/kasan.rst b/Documentation/dev-tools/kasan.rst
index 4968b2aa60c8..3a8bd40ad905 100644
--- a/Documentation/dev-tools/kasan.rst
+++ b/Documentation/dev-tools/kasan.rst

@@ -392,7 +392,7 @@ reserved to tag freed memory regions.
  If the hardware does not support MTE (pre ARMv8.5), Hardware Tag-Based KASAN
  will not be enabled. In this case, all KASAN boot parameters are ignored.
  
-Note that enabling CONFIG_KASAN_HW_TAGS always results in in-kernel TBI being
+Note that enabling CONFIG_KASAN_HW_TAGS always results in-kernel TBI being

  enabled. Even when ``kasan.mode=off`` is provided or when the hardware does not
  support MTE (but supports TBI).
  

diff --git a/Documentation/networking/switchdev.rst b/Documentation/networking/switchdev.rst
index 2966b7122f05..948bce44ca9b 100644
--- a/Documentation/networking/switchdev.rst
+++ b/Documentation/networking/switchdev.rst

@@ -162,7 +162,7 @@ The switchdev driver can know a particular port's position in the topology by
  monitoring NETDEV_CHANGEUPPER notifications.  For example, a port moved into a
  bond will see its upper master change.  If that bond is moved into a bridge,
  the bond's upper master will change.  And so on.  The driver will track such
-movements to know what position a port is in in the overall topology by
+movements to know what position a port is in the overall topology by

  registering for netdevice events and acting on NETDEV_CHANGEUPPER.
  
  L2 Forwarding Offload

diff --git a/Documentation/virt/uml/user_mode_linux_howto_v2.rst b/Documentation/virt/uml/user_mode_linux_howto_v2.rst
index c37e8e594d12..7b08738c30aa 100644
--- a/Documentation/virt/uml/user_mode_linux_howto_v2.rst
+++ b/Documentation/virt/uml/user_mode_linux_howto_v2.rst

@@ -1092,7 +1092,7 @@ be formatted as plain text.
  
  Developing always goes hand in hand with debugging. First of all,
  you can always run UML under gdb and there will be a whole section
-later on on how to do that. That, however, is not the only way to
+later on how to do that. That, however, is not the only way to