On Fri, Mar 13, 2026 at 2:16 AM Jakub Kicinski [off-list ref] wrote:

On Wed, 11 Mar 2026 18:03:35 +0100 Bartosz Golaszewski wrote:

quoted

Add support for the firmware-managed variant of the DesignWare MAC on
the sa8255p platform. This series contains new DT bindings and driver
changes required to support the MAC in the STMMAC driver.

It also reorganizes the ethqos code quite a bit to make the introduction
of power domains into the driver a bit easier on the eye.

Not entirely sure what the conclusion was in the sub-thread with Russell
but FWIW this doesn't apply to net-next as posted so respin will be
needed either way.

net-next is quite the moving target, isn't it? I did just that between
v7 and v8. :)

As for Russell's response: I think this is the third time we're doing
this for this driver. :( This series is not touching the existing
functionality and rebasing of Russell's changes on top of this should
for most part be trivial. The core of the changeset is to add support
for power domains to enable ethernet on SCMI driven SoCs. I would
really appreciate it if we could get it upstream and then any
subsequent rework can take into account the two types of systems we
support.

Russell: I see your point and didn't mind the first two times but it's
been way too long since I posted v1.

Bartosz