This series converts the remaining glue drivers that support
multi-interface to use stmmac_get_phy_intf_sel(). The reason these
drivers are not converted to the set_phy_intf_sel() method is
because it is unclear whether there are ordering dependencies that
would prevent it.

For example, reading the stm32mp2 documentation, it is required to
set the ETH1_SEL field while the dwmac core is in reset and before
clocks are enabled. This requirement can not be satsified at the
moment (but could with further changes.)

v2:
- sending meson8b seperately
- updated a number of commit descriptions: PHY_INTF_SEL_xxx ->
  PHY_INTF_SEL_x, added note where GMII no longer errors out.

 .../net/ethernet/stmicro/stmmac/dwmac-loongson1.c  | 18 ++---
 .../net/ethernet/stmicro/stmmac/dwmac-mediatek.c   | 77 ++++++++--------------
 .../net/ethernet/stmicro/stmmac/dwmac-starfive.c   | 24 ++-----
 drivers/net/ethernet/stmicro/stmmac/dwmac-stm32.c  | 44 +++++++------
 .../net/ethernet/stmicro/stmmac/dwmac-visconti.c   | 26 ++------
 5 files changed, 70 insertions(+), 119 deletions(-)

-- 
RMK's Patch system: https://www.armlinux.org.uk/developer/patches/
FTTP is here! 80Mbps down 10Mbps up. Decent connectivity at last!