On Wed, Oct 29, 2025 at 02:03:30PM +0100, Andrew Lunn wrote:

On Wed, Oct 29, 2025 at 11:23:41AM +0100, Buday Csaba wrote:

quoted

Unify the handling of reset properties for an `mdio_device`.
Replace mdiobus_register_gpiod() and mdiobus_register_reset() with
mdio_device_register_reset() and mdio_device_unregister_reset(),
and move them from mdio_bus.c to mdio_device.c, where they belong.

You should probably mention here that there are two sets of reset
properties. One set applies to the bus as a whole, and the second is
per device on the bus. You would expect the whole bus properties to be
handled in mdio_bus.c, where as the per device properties might make
more sense in mdio_device.c. So you can comment you are only moving
the per device reset code.

Okay, I will do that.

quoted

The new functions handle both reset-controllers and reset-gpios,
and also read the corresponding firmware properties from the
device tree, which were previously handled in fwnode_mdio.c.
This makes tracking the reset properties easier.

Please split this patch.

It is normal when moving a function to just move it, make no
additional changes. That makes the change smaller, easier to review,
since it is all about, does the new location make sense?

Once it is in the new location, you can then have patches which
refactor it.

Understood, I will change it accordingly.

quoted

-static int mdiobus_register_gpiod(struct mdio_device *mdiodev)
-{
-	/* Deassert the optional reset signal */
-	mdiodev->reset_gpio = gpiod_get_optional(&mdiodev->dev,
-						 "reset", GPIOD_OUT_LOW);
-	if (IS_ERR(mdiodev->reset_gpio))
-		return PTR_ERR(mdiodev->reset_gpio);
-
-	if (mdiodev->reset_gpio)
-		gpiod_set_consumer_name(mdiodev->reset_gpio, "PHY reset");
-
-	return 0;
-}
-

quoted

+/**
+ * mdio_device_register_reset - Read and initialize the reset properties of
+ *				an mdio device
+ * @mdiodev: mdio_device structure
+ *
+ * Return: Zero if successful, negative error code on failure
+ */
+int mdio_device_register_reset(struct mdio_device *mdiodev)
+{
+
+	return 0;
+}
+EXPORT_SYMBOL(mdio_device_register_reset);

Before it did not require an EXPORT_SYMBOL, but now it does?  That
makes me wounder if it is in the correct place. This should be a core
function, why would something outside of the core need it?

I am using these in the third patch in fwnode_mdio.c, so I assumed it was
necessary. But you are right, neither can be in a module. I will remove it.

Also, please use the _GPL variant.

	Andrew

Csaba