Re: [PATCH net-next v2 09/10] arm64: dts: allwinner: t527: avaota-a1: enable second Ethernet port
From: Jernej Škrabec <jernej.skrabec@gmail.com>
Date: 2025-08-13 15:28:02
Also in:
linux-arm-kernel, linux-devicetree, linux-sunxi, lkml
Dne sreda, 13. avgust 2025 ob 16:55:39 Srednjeevropski poletni čas je Chen-Yu Tsai napisal(a):
From: Chen-Yu Tsai <redacted> On the Avaota A1 board, the second Ethernet controller, aka the GMAC200, is connected to a second external RTL8211F-CG PHY. The PHY uses an external 25MHz crystal, and has the SoC's PJ16 pin connected to its reset pin. Enable the second Ethernet port. Also fix up the label for the existing external PHY connected to the first Ethernet port. Signed-off-by: Chen-Yu Tsai <redacted>
Acked-by: Jernej Skrabec <jernej.skrabec@gmail.com> Best regards, Jernej
quoted hunk ↗ jump to hunk
--- Changes since v1: - Switch to generic (tx|rx)-internal-delay-ps properties --- .../dts/allwinner/sun55i-t527-avaota-a1.dts | 26 +++++++++++++++++-- 1 file changed, 24 insertions(+), 2 deletions(-)diff --git a/arch/arm64/boot/dts/allwinner/sun55i-t527-avaota-a1.dts b/arch/arm64/boot/dts/allwinner/sun55i-t527-avaota-a1.dts index e7713678208d..f540965ffaa4 100644 --- a/arch/arm64/boot/dts/allwinner/sun55i-t527-avaota-a1.dts +++ b/arch/arm64/boot/dts/allwinner/sun55i-t527-avaota-a1.dts@@ -13,6 +13,7 @@ / { aliases { ethernet0 = &gmac0; + ethernet1 = &gmac1; serial0 = &uart0; };@@ -67,7 +68,7 @@ &ehci1 { &gmac0 { phy-mode = "rgmii-id"; - phy-handle = <&ext_rgmii_phy>; + phy-handle = <&ext_rgmii0_phy>; phy-supply = <®_dcdc4>; allwinner,tx-delay-ps = <100>;@@ -76,13 +77,24 @@ &gmac0 { status = "okay"; }; +&gmac1 { + phy-mode = "rgmii-id"; + phy-handle = <&ext_rgmii1_phy>; + phy-supply = <®_dcdc4>; + + tx-internal-delay-ps = <100>; + rx-internal-delay-ps = <100>; + + status = "okay"; +}; + &gpu { mali-supply = <®_dcdc2>; status = "okay"; }; &mdio0 { - ext_rgmii_phy: ethernet-phy@1 { + ext_rgmii0_phy: ethernet-phy@1 { compatible = "ethernet-phy-ieee802.3-c22"; reg = <1>; reset-gpios = <&pio 7 8 GPIO_ACTIVE_LOW>; /* PH8 */@@ -91,6 +103,16 @@ ext_rgmii_phy: ethernet-phy@1 { }; }; +&mdio1 { + ext_rgmii1_phy: ethernet-phy@1 { + compatible = "ethernet-phy-ieee802.3-c22"; + reg = <1>; + reset-gpios = <&pio 9 16 GPIO_ACTIVE_LOW>; /* PJ16 */ + reset-assert-us = <10000>; + reset-deassert-us = <150000>; + }; +}; + &mmc0 { vmmc-supply = <®_cldo3>; cd-gpios = <&pio 5 6 (GPIO_ACTIVE_LOW | GPIO_PULL_UP)>; /* PF6 */