On Mo, 2025-06-02 at 13:53 +0400, George Moussalem via B4 Relay wrote:
From: George Moussalem <redacted>
The IPQ5018 SoC contains a single internal Gigabit Ethernet PHY which
provides an MDI interface directly to an RJ45 connector or an external
switch over a PHY to PHY link.
The PHY supports 10/100/1000 mbps link modes, CDT, auto-negotiation and
802.3az EEE.
Let's add support for this PHY in the at803x driver as it falls within
the Qualcomm Atheros OUI.
Signed-off-by: George Moussalem <redacted>
---
drivers/net/phy/qcom/Kconfig | 2 +-
drivers/net/phy/qcom/at803x.c | 185 ++++++++++++++++++++++++++++++++++++++++--
2 files changed, 178 insertions(+), 9 deletions(-)
[...]
quoted hunk ↗ jump to hunk
diff --git a/drivers/net/phy/qcom/at803x.c b/drivers/net/phy/qcom/at803x.c
index 26350b962890b0321153d74758b13d817407d094..c148e245b5391c5da374ace8609dcdfd8284732d 100644
--- a/drivers/net/phy/qcom/at803x.c
+++ b/drivers/net/phy/qcom/at803x.c
[...]
quoted hunk ↗ jump to hunk
+static int ipq5018_probe(struct phy_device *phydev)
+{
+ struct device *dev = &phydev->mdio.dev;
+ struct ipq5018_priv *priv;
+ int ret;
+
+ priv = devm_kzalloc(dev, sizeof(*priv), GFP_KERNEL);
+ if (!priv)
+ return -ENOMEM;
+
+ priv->set_short_cable_dac = of_property_read_bool(dev->of_node,
+ "qcom,dac-preset-short-cable");
+
+ priv->rst = devm_reset_control_array_get_exclusive(dev);
Both dt-bindings and dts patch only show a single reset. Is there a
reason this is a reset_control_array?
regards
Philipp