[PATCH net-next v4 7/8] net: ethtool: plca: Use per-PHY DUMP operations
From: Maxime Chevallier <maxime.chevallier@bootlin.com>
Date: 2025-03-24 10:40:28
Also in:
linux-arm-kernel, lkml
Subsystem:
networking [ethtool], networking [general], plca reconciliation sublayer (ieee802.3 clause 148), the rest · Maintainers:
Andrew Lunn, Jakub Kicinski, "David S. Miller", Eric Dumazet, Paolo Abeni, Piergiorgio Beruto, Linus Torvalds
Leverage the per-phy ethnl DUMP helpers in case we have more that one PLCA-able PHY on the link. This is done for both PLCA status and PLCA config. Signed-off-by: Maxime Chevallier <maxime.chevallier@bootlin.com> --- V4 : No changes net/ethtool/plca.c | 12 ++++++++++++ 1 file changed, 12 insertions(+)
diff --git a/net/ethtool/plca.c b/net/ethtool/plca.c
index e1f7820a6158..2148ff607561 100644
--- a/net/ethtool/plca.c
+++ b/net/ethtool/plca.c@@ -191,6 +191,12 @@ const struct ethnl_request_ops ethnl_plca_cfg_request_ops = { .set = ethnl_set_plca, .set_ntf_cmd = ETHTOOL_MSG_PLCA_NTF, + + .dump_start = ethnl_dump_start_perphy, + .dump_one_dev = ethnl_dump_one_dev_perphy, + .dump_done = ethnl_dump_done_perphy, + + .allow_pernetdev_dump = true, }; // PLCA get status message -------------------------------------------------- //
@@ -268,4 +274,10 @@ const struct ethnl_request_ops ethnl_plca_status_request_ops = { .prepare_data = plca_get_status_prepare_data, .reply_size = plca_get_status_reply_size, .fill_reply = plca_get_status_fill_reply, + + .dump_start = ethnl_dump_start_perphy, + .dump_one_dev = ethnl_dump_one_dev_perphy, + .dump_done = ethnl_dump_done_perphy, + + .allow_pernetdev_dump = true, };
--
2.48.1