On Sun, Aug 25, 2024 at 10:17:04PM +0530, Ayush Singh wrote:

Adds support for beagleplay cc1352 co-processor firmware upgrade using
kernel Firmware Upload API. Uses ROM based bootloader present in
cc13x2x7 and cc26x2x7 platforms for flashing over UART.

Communication with the bootloader can be moved out of gb-beagleplay
driver if required, but I am keeping it here since there are no
immediate plans to use the on-board cc1352p7 for anything other than
greybus (BeagleConnect Technology). Additionally, there do not seem to
any other devices using cc1352p7 or its cousins as a co-processor.

Bootloader backdoor and reset GPIOs are used to enable cc1352p7 bootloader
backdoor for flashing. Flashing is skipped in case we are trying to flash
the same image as the one that is currently present. This is determined by
CRC32 calculation of the supplied firmware and flash data.

We also do a CRC32 check after flashing to ensure that the firmware was
flashed properly.

Link: https://www.ti.com/lit/ug/swcu192/swcu192.pdf Ti CC1352P7 Technical Specification

Changes in v3:
- Spelling fixes in cover letter
- Add Ack by Rob Herring on Patch 1

Where?

Just use b4 to collect tags.

Best regards,
Krzysztof