On 11/21/23 9:02 AM, claudiu beznea wrote:

[...]

quoted

quoted

From: Claudiu Beznea <claudiu.beznea.uj@bp.renesas.com>

Hardware manual of RZ/G3S (and RZ/G2L) specifies the following on the
description of CXR35 register (chapter "PHY interface select register
(CXR35)"): "After release reset, make write-access to this register before
making write-access to other registers (except MDIOMOD). Even if not need
to change the value of this register, make write-access to this register
at least one time. Because RGMII/MII MODE is recognized by accessing this
register".

The setup procedure for EMAC module (chapter "Setup procedure" of RZ/G3S,
RZ/G2L manuals) specifies the E-MAC.CXR35 register is the first EMAC
register that is to be configured.

Note [A] from chapter "PHY interface select register (CXR35)" specifies
the following:
[A] The case which CXR35 SEL_XMII is used for the selection of RGMII/MII
in APB Clock 100 MHz.
(1) To use RGMII interface, Set ‘H’03E8_0000’ to this register.
(2) To use MII interface, Set ‘H’03E8_0002’ to this register.

Take into account these indication.

Fixes: 1089877ada8d ("ravb: Add RZ/G2L MII interface support")

   The bug fixes should be submitted separately and against the net.git repo...

OK, thanks for pointing it.

   And I think Linus' repo will do as well...

MBR, Sergey