[PATCH v2 11/15] dt-bindings: gpio: gpio_oxnas: remove obsolete bindings
From: Neil Armstrong <neil.armstrong@linaro.org>
Date: 2023-06-30 17:00:15
Also in:
linux-arm-kernel, linux-clk, linux-devicetree, linux-gpio, linux-pm, lkml
Subsystem:
gpio subsystem, open firmware and flattened device tree bindings, the rest · Maintainers:
Linus Walleij, Bartosz Golaszewski, Rob Herring, Krzysztof Kozlowski, Conor Dooley, Linus Torvalds
Due to lack of maintenance and stall of development for a few years now, and since no new features will ever be added upstream, remove the OX810 and OX820 gpio bindings. Acked-by: Krzysztof Kozlowski <redacted> Acked-by: Linus Walleij <redacted> Acked-by: Arnd Bergmann <arnd@arndb.de> Acked-by: Daniel Golle <daniel@makrotopia.org> Signed-off-by: Neil Armstrong <neil.armstrong@linaro.org> --- .../devicetree/bindings/gpio/gpio_oxnas.txt | 47 ---------------------- 1 file changed, 47 deletions(-)
diff --git a/Documentation/devicetree/bindings/gpio/gpio_oxnas.txt b/Documentation/devicetree/bindings/gpio/gpio_oxnas.txt
deleted file mode 100644
index 966514744df4..000000000000
--- a/Documentation/devicetree/bindings/gpio/gpio_oxnas.txt
+++ /dev/null@@ -1,47 +0,0 @@ -* Oxford Semiconductor OXNAS SoC GPIO Controller - -Please refer to gpio.txt for generic information regarding GPIO bindings. - -Required properties: - - compatible: "oxsemi,ox810se-gpio" or "oxsemi,ox820-gpio" - - reg: Base address and length for the device. - - interrupts: The port interrupt shared by all pins. - - gpio-controller: Marks the port as GPIO controller. - - #gpio-cells: Two. The first cell is the pin number and - the second cell is used to specify the gpio polarity as defined in - defined in <dt-bindings/gpio/gpio.h>: - 0 = GPIO_ACTIVE_HIGH - 1 = GPIO_ACTIVE_LOW - - interrupt-controller: Marks the device node as an interrupt controller. - - #interrupt-cells: Two. The first cell is the GPIO number and second cell - is used to specify the trigger type as defined in - <dt-bindings/interrupt-controller/irq.h>: - IRQ_TYPE_EDGE_RISING - IRQ_TYPE_EDGE_FALLING - IRQ_TYPE_EDGE_BOTH - - gpio-ranges: Interaction with the PINCTRL subsystem, it also specifies the - gpio base and count, should be in the format of numeric-gpio-range as - specified in the gpio.txt file. - -Example: - -gpio0: gpio@0 { - compatible = "oxsemi,ox810se-gpio"; - reg = <0x000000 0x100000>; - interrupts = <21>; - #gpio-cells = <2>; - gpio-controller; - interrupt-controller; - #interrupt-cells = <2>; - gpio-ranges = <&pinctrl 0 0 32>; -}; - -keys { - ... - - button-esc { - label = "ESC"; - linux,code = <1>; - gpios = <&gpio0 12 0>; - }; -};
--
2.34.1