Hello,

On Wed, Sep 21, 2022 at 05:00:02PM +0000, Yafang Shao wrote:

A new item 'bpf' is introduced into memory.stat, then we can get the memory
consumed by bpf. Currently only the memory of bpf-map is accounted.
The accouting of this new item is implemented with scope-based accouting,
which is similar to set_active_memcg(). In this scope, the memory allocated
will be accounted or unaccounted to a specific item, which is specified by
set_active_memcg_item().

Imma let memcg folks comment on the implementation. Hmm... I wonder how this
would tie in with the BPF memory allocator Alexei is working on.

The result in cgroup v1 as follows,
	$ cat /sys/fs/cgroup/memory/foo/memory.stat | grep bpf
	bpf 109056000
	total_bpf 109056000
After the map is removed, the counter will become zero again.
        $ cat /sys/fs/cgroup/memory/foo/memory.stat | grep bpf
        bpf 0
        total_bpf 0

The 'bpf' may not be 0 after the bpf-map is destroyed, because there may be
cached objects.

What's the difference between bpf and total_bpf? Where's total_bpf
implemented? It doesn't seem to be anywhere. Please also update
Documentation/admin-guide/cgroup-v2.rst.

Note that there's no kmemcg in root memory cgroup, so the item 'bpf' will
be always 0 in root memory cgroup. If a bpf-map is charged into root memcg
directly, its memory size will not be accounted, so the 'total_bpf' can't
be used to monitor system-wide bpf memory consumption yet.

So, system-level accounting is usually handled separately as it's most
likely that we'd want the same stat at the system level even when cgroup is
not implemented. Here, too, it'd make sense to first implement system level
bpf memory usage accounting, expose that through /proc/meminfo and then use
the same source for root level cgroup stat.

Thanks.

-- 
tejun