Re: [PATCH v2 5/6] dt-bindings: net: Add NCSI bindings

From
Jiaqing Zhao <hidden>
Date
2022-06-14 02:55:25
Also in
linux-devicetree, lkml, openbmc
Reply to
Rob Herring, 2022-06-13
On 2022-06-13 23:28, Rob Herring wrote:
On Fri, Jun 10, 2022 at 9:09 PM Jiaqing Zhao
[off-list ref] wrote:
quoted
On 2022-06-11 07:19, Rob Herring wrote:
quoted
On Sat, 11 Jun 2022 00:59:39 +0800, Jiaqing Zhao wrote:
quoted
Add devicetree bindings for NCSI VLAN modes. This allows VLAN mode to
be configured in devicetree.

Signed-off-by: Jiaqing Zhao <redacted>
---
 .../devicetree/bindings/net/ncsi.yaml         | 34 +++++++++++++++++++
 MAINTAINERS                                   |  2 ++
 include/dt-bindings/net/ncsi.h                | 15 ++++++++
 3 files changed, 51 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/net/ncsi.yaml
 create mode 100644 include/dt-bindings/net/ncsi.h
My bot found errors running 'make DT_CHECKER_FLAGS=-m dt_binding_check'
on your patch (DT_CHECKER_FLAGS is new in v5.13):

yamllint warnings/errors:

dtschema/dtc warnings/errors:
/builds/robherring/linux-dt-review/Documentation/devicetree/bindings/net/ncsi.yaml: 'oneOf' conditional failed, one must be fixed:
      'unevaluatedProperties' is a required property
      'additionalProperties' is a required property
      hint: Either unevaluatedProperties or additionalProperties must be present
      from schema $id: http://devicetree.org/meta-schemas/core.yaml#
/builds/robherring/linux-dt-review/Documentation/devicetree/bindings/net/ncsi.yaml: ignoring, error in schema:
/builds/robherring/linux-dt-review/Documentation/devicetree/bindings/net/ncsi.example.dtb: ethernet@1e660000: 'ncsi,vlan-mode' does not match any of the regexes
      From schema: /builds/robherring/linux-dt-review/Documentation/devicetree/bindings/vendor-prefixes.yaml
I saw vendor-prefix.yaml says do not add non-vendor prefixes to the list. Since "ncsi" is not a vendor, may I ask what is the suggested replacement for 'ncsi,vlan-mode'? Will 'ncsi-vlan-mode' be fine?
I don't know. What is NCSI? Is it specific to certain MACs? Why do you
need to set this up in DT? Network configuration is typically done in
userspace, so putting VLAN config in DT doesn't seem right. All
questions your commit message should answer.
NCSI is a protocol that uses an external MAC+PHY like a PHY, the
topology looks like:

         Packets + NCSI commands              Packets
     MAC-------------------------External MAC---------PHY

Some MACs like ftgmac100 driver supports using NCSI instead of PHY,
the operation mode is configured by a DT option "use-ncsi". The NCSI
external MAC has its own configuration, like VLAN filter mode of it,
and all NCSI devices uses a generic driver. So I these external mac
configurations to DT as they are device properties to kernel. Userspace
is only able to configure the "internal" MAC.
quoted
quoted
Documentation/devicetree/bindings/net/ncsi.example.dtb:0:0: /example-0/ethernet@1e660000: failed to match any schema with compatible: ['aspeed,ast2600-mac', 'faraday,ftgmac100']
Documentation/devicetree/bindings/net/ncsi.example.dtb:0:0: /example-0/ethernet@1e660000: failed to match any schema with compatible: ['aspeed,ast2600-mac', 'faraday,ftgmac100']
The ftgmac100 it depends on uses a txt document instead of an yaml schema. And I see there is other schemas having the same error, can this be ignored?
No. Don't add to the list. Once all the existing warnings (~40) are
fixed, then this will be turned on by default.
Sure, I'll put this to ftgmac100.txt instead of separate yaml file.
quoted
And I've got one more question. The ncsi driver does not has its own compatible field, instead, it is enabled by setting the "use-ncsi" property of some specific mac drivers. Though currently only ftgmac100 supports ncsi in upstream kernel, it may be used by other mac drivers in the future. What do you think is a proper way for defining the ncsi schema? Having it in a separate yaml like this patch or add the properties to all the mac yamls that supports yaml? If the former way is preferred, how should the schema be defined without "compatible"?
If it is a function of driver support or not, then it doesn't belong in DT.

Rob
It's a hardware operation mode of the external MAC, I think it's
reasonable to put it in DT.

There is also a previous patch adding NCSI MAC config "mlx,multi-host"
in DT at https://lore.kernel.org/netdev/20200108234341.2590674-1-vijaykhemka@fb.com/T/ (local)
I referred this for my implementation, though it is undocumented.

Jiaqing
Thread (17 messages) 17 messages, 3 authors, last reply 2022-06-14
Keyboard shortcuts
hback out one level
jnext message in thread / next series-diff position
kprevious message in thread / previous series-diff position
ldrill in
Escclose help / fold thread tree
?toggle this help