[PATCH net-next v2 1/1] net: phy: dp83867: retrigger SGMII AN when link change

@@ -137,6 +137,7 @@
 #define DP83867_DOWNSHIFT_2_COUNT	2
 #define DP83867_DOWNSHIFT_4_COUNT	4
 #define DP83867_DOWNSHIFT_8_COUNT	8
+#define DP83867_SGMII_AUTONEG_EN	BIT(7)
 
 /* CFG3 bits */
 #define DP83867_CFG3_INT_OE			BIT(7)

@@ -855,6 +856,32 @@ static int dp83867_phy_reset(struct phy_device *phydev)
 			 DP83867_PHYCR_FORCE_LINK_GOOD, 0);
 }
 
+static void dp83867_link_change_notify(struct phy_device *phydev)
+{
+	/* There is a limitation in DP83867 PHY device where SGMII AN is
+	 * only triggered once after the device is booted up. Even after the
+	 * PHY TPI is down and up again, SGMII AN is not triggered and
+	 * hence no new in-band message from PHY to MAC side SGMII.
+	 * This could cause an issue during power up, when PHY is up prior
+	 * to MAC. At this condition, once MAC side SGMII is up, MAC side
+	 * SGMII wouldn`t receive new in-band message from TI PHY with
+	 * correct link status, speed and duplex info.
+	 * Thus, implemented a SW solution here to retrigger SGMII Auto-Neg
+	 * whenever there is a link change.
+	 */
+	if (phydev->interface == PHY_INTERFACE_MODE_SGMII) {
+		int val = 0;
+
+		val = phy_clear_bits(phydev, DP83867_CFG2,
+				     DP83867_SGMII_AUTONEG_EN);
+		if (val < 0)
+			return;
+
+		phy_set_bits(phydev, DP83867_CFG2,
+			     DP83867_SGMII_AUTONEG_EN);
+	}
+}
+
 static struct phy_driver dp83867_driver[] = {
 	{
 		.phy_id		= DP83867_PHY_ID,

@@ -879,6 +906,8 @@ static struct phy_driver dp83867_driver[] = {
 
 		.suspend	= genphy_suspend,
 		.resume		= genphy_resume,
+
+		.link_change_notify = dp83867_link_change_notify,
 	},
 };
 module_phy_driver(dp83867_driver);