Re: [RFC 0/2] Add Rx checksum offload support

On 11/23/21 4:31 PM, Biju Das wrote:

TOE has hw support for calculating IP header checkum for IPV4 and
TCP/UDP/ICMP checksum for both IPV4 and IPV6.

This patch series aims to adds Rx checksum offload supported by TOE.

For RX, The result of checksum calculation is attached to last 4byte
of ethernet frames. First 2bytes is result of IPV4 header checksum 
and next 2 bytes is TCP/UDP/ICMP.

if frame does not have error "0000" attached to checksum calculation
result. For unsupported frames "ffff" is attached to checksum calculation
result. Cases like IPV6, IPV4 header is always set to "FFFF".

we can test this functionality by the below commands

ethtool -K eth0 rx on --> to turn on Rx checksum offload
ethtool -K eth0 rx off --> to turn off Rx checksum offload

Biju Das (2):
  ravb: Fillup ravb_set_features_gbeth() stub
  ravb: Add Rx checksum offload support

   That's all fine but why in the world did you separate these patches?

MBR, Sergey