Re: [RFC v2] mac80211: minstrel_ht: do not set RTS/CTS flag for fallback rates

On 2021-11-16 22:28, Peter Seiderer wrote:

Despite the 'RTS thr:off' setting a wireshark trace of IBSS
traffic with HT40 mode enabled between two ath9k cards revealed
some RTS/CTS traffic.

Debug and code analysis showed that most places setting
IEEE80211_TX_RC_USE_RTS_CTS respect the RTS strategy by
evaluating rts_threshold, e.g. net/mac80211/tx.c:

  698         /* set up RTS protection if desired */
  699         if (len > tx->local->hw.wiphy->rts_threshold) {
  700                 txrc.rts = true;
  701         }
  702
  703         info->control.use_rts = txrc.rts;

or drivers/net/wireless/ath/ath9k/xmit.c

1238                 /*
1239                  * Handle RTS threshold for unaggregated HT frames.
1240                  */
1241                 if (bf_isampdu(bf) && !bf_isaggr(bf) &&
1242                     (rates[i].flags & IEEE80211_TX_RC_MCS) &&
1243                     unlikely(rts_thresh != (u32) -1)) {
1244                         if (!rts_thresh || (len > rts_thresh))
1245                                 rts = true;
1246                 }

The only place setting IEEE80211_TX_RC_USE_RTS_CTS unconditionally
was found in net/mac80211/rc80211_minstrel_ht.c.

As the use_rts value is only calculated after hitting the minstrel_ht code
preferre to not set IEEE80211_TX_RC_USE_RTS_CTS (and overruling the
RTS threshold setting) for the fallback rates case.

The idea behind the this part of minstrel_ht code is to avoid the 
overhead of RTS/CTS for transmissions using the primary rate and to 
increase the reliability of retransmissions by adding it for fallback 
rates. This is completely unrelated to the RTS threshold.

If you don't want this behavior, I'm fine with adding a way to 
explicitly disable it. However, I do think leaving it on by default 
makes sense.

- Felix